HobbyKing
FRONT WHEEL SHOCK SHAFT - 1/10 TURNIGY GT-10X PAN CAR (2PCS)
,
Front Wheel Shock Shaft - 1/10 Turnigy GT-10X Pan Car ...HobbyKing
REAR BODY MOUNT - 1/10 TURNIGY GT-10X PAN CAR (2PCS)
,
Rear Body Mount - 1/10 Turnigy GT-10X Pan Car (2pcs)HobbyKing
1/10 QUANUM SKULL CRUSHER 2WD BRUSHLESS MONSTER TRUCK (ARR)
| Length | 467mm |
| Wheeltrack | 325mm |
| Wheelbase | 274mm |
| Tire Size | 136x71mm |
| Wheel Diameter | 82mm (12mm hex) |
| Gear Ratio | 10.86 |
| *Note | The user manual with exploded view diagram is available for download under the "Files" tab below. |
Features:, • Almost ready to run with power system and steering servo pre-installed, Specs:, Battery Tray Size:, 140L x 48W x 34H (mm), ESC:, 35A (190A burst) brushless (pre-installed), Motor:, 3650 size 2700KV brushless inrunner (pre-installed), Servo:, High-torque standard size (pre-installed), Includes:, Quanum Skull Crusher 1/10 Monster Truck, Requires:, Your own 2CH transmitter and receiver,
Are you ready for the ultimate in bone breaking, car ...5 Reviews
HobbyKing
TURNIGY TGY-S902 METAL GEAR DIGITAL ROBOT SERVO 13KG / 0.14SEC / 58G
| Model | TGY-S902 |
| Operating Voltage | 6.0V / 7.2V |
| Stall Torque | 12.5kg.cm /13kg.cm |
| Size | 40.8X20.1X37.6mm |
| Weight | 58g |
| Motor | Coreless Type |
| Ball bearing | 2BB |
| Gear | Metal |
| Plug | JR Type |
Operating Speed:, 0.16sec.60º/ 0.14sec.60º,
Turnigy TGY-S902 Metal Gear Digital Robot Servo 13kg / 0.14sec ...HobbyKing
AQ-600 QUADCOPTER FRAME - REPLACEMENT BATTERY HOLDER
,
AQ-600 Quadcopter Frame - Replacement Battery HolderHobbyKing
"HARD ONE" 0.6M HARDENED HELICOPTER PINION GEAR 5MM SHAFT - 24T
Note:, If you have a Neu Motor - Neu motor shafts are .05mm over size. The solution to this is to run the motor at low rpm and touch a piece of 400 grit sand paper against the shaft for a couple of seconds. Then the pinions fit perfectly.,
"Hard One" 0.6M Hardened Helicopter Pinion Gear 5mm Shaft - ...HobbyKing
BALL BEARING (10*5*4) - 1/10 QUANUM VANDAL 4WD RACING BUGGY (6PCS)
,
Ball Bearing (10*5*4) - 1/10 Quanum Vandal 4WD Racing Buggy ...HobbyKing
HOBBYKING BRUSHLESS CAR ESC 60A W/ REVERSE
| Input voltage | 2-4S Lithium batteries / 4~15 Ni-xx |
| Cont. Current | 60A |
| BEC output | 3A/5V (Switch) |
| Size( length X width X high) | 47x41x29mm |
| Weight | 82g |
Features:, Full protection feature including low voltage, over-heat, throttle signal lost, startup, Specification:,
Standard 60A car esc with forward reverse and a good ...5 Reviews
HobbyKing
HOBBYKING BRUSHLESS CAR ESC 30A W/ REVERSE
| Input voltage | 2-3S Lithium batteries / 4~9 Ni-xx |
| Cont. Current | 30A |
| BEC output | 2A /5V (Linear) |
| Size( length X width X high) | 45x32x20mm |
| Weight | 51g |
Features:, Full protection feature including low voltage, over-heat, throttle signal lost, startup, Specification:,
A standard car esc. providing forward and reverse with a ...5 Reviews
HobbyKing
HOBBY KING PROGRAMMING CARD FOR CAR ESC
,
Hobby King Programming Card for Car ESC LED programming card ...5 Reviews
HobbyKing
GEEBEE R2 1.20 FIBERGLASS KIT
| Wing Span | 1850mm |
| Length | 1160mm |
| Servo | 4~5 x Standard Servo |
| Motor | Glow |
5 Reviews
HobbyKing
HOBBY KING 150A HIGH PERFORMANCE BRUSHLESS CAR ESC
| Cont./Burst Current | 150A/1080A |
| Resistance | 0.0002 ohm |
| Suitable Brushless Motor | 3.5T (3660) |
| Dimension | 55(W)*60(L) *40(H) |
| Weight | 150g |
Features:, Enhanced throttle response, excellent acceleration,strong brakes and throttle linearity, Multiple protection features: Low voltage cut-off protection, over-heat protection, throttle signal loss protection and motor blocked protection, Specification:, Suitable Car:, 1/5, 1/8 on-road and off-road cars / trucks For competitive race, Battery:, 6-18 cells Ni-xx (NiMH / NiCd) 2-6 cells Li-Po, BEC Output:, 6V/3A of switch mode built-in BEC, Motor Type:, Sensorless and sensored brushless motor (2 Pole Only), WARNING:, These ESC are not suited to 4 pole motors. Using this ESC with a 4 Pole motor will result in damaging the ESC.,
Hobby King 150A High performance Brushless ESC is suitable for ...5 Reviews
HobbyKing
550MM MS COMPOSIT 3D NIGHT MAIN BLADES
| Length | 550mm |
| Width | 50mm |
| Grip | 12mm |
| Hole | 4mm |
5 Reviews
HobbyKing
FIBERGLASS CANOPY FOR TREX-700 NITRO
,
Fiberglass Canopy for Trex-700 Nitro3 Reviews
HobbyKing
P-51D MONSTER MUSTANG 1.55M 6CH XL-EPO - 61INCH PNF (GREEN)
| Length | 1350mm |
| WingSpan | 1550mm |
| Propeller | 4 blade (included) |
| Weight | 2300g |
| Motor | C4250 Brushless outrunner 600kv (included) |
| ESC | 45A (included) |
| Battery | 14.8v 2600~3000mAh 4S1P (not included) |
| Servos | 8 units (included) |
| Retracts | 3 x Electric Retracts (included) |
5 Reviews