HobbyKing
ORANGERX R415 SPEKTRUM DSM2 COMPATIBLE 4CH MICRO 2.4GHZ RECEIVER
| Voltage | 3.6~9v |
NOTE:, 1) Accepted by the MAAA in Australia, see the MAAA MOP58 for guidance,
Compatible with all Spektrum DSM2 transmitters. A perfect small foamie ...5 Reviews
HobbyKing
2 PIN JST TO 6 X E-FLIGHT ULTRA MICRO PLUG CHARGING HARNESS
,
2 Pin JST to 6 x E-Flight Ultra Micro charging ...5 Reviews
HobbyKing
ORANGERX R710 SPEKTRUM DSM2 COMPATIBLE 7CH RECEIVER W/FAILSAFE
| Input voltage | 3.7~9.6V. |
| Failsafe | All channels to bind position at signal loss. |
NOTE:, 1) Accepted by the MAAA in Australia, see the MAAA MOP58 for guidance,
OrangeRx R710 full failsafe, S.Bus and satellite port ready. The ...5 Reviews
HobbyKing
HOBBYKING MULTI-ROTOR CONTROL BOARD V2.1 (ATMEGA168PA)
| Weight | 14.5 gram |
| Gyro | Murata Piezo |
| Input Voltage | 3.3-5.5V |
| Signal from Receiver | 1520us (4 channels) |
| Signal to ESC | 1520us |
Size:, 50.5mm x 50.5mm x 23.5mm, IC:Atmega168PA, Note:, A user manual is available under the files tab.,
Based on and built in conjunction with the original QUADBoard ...5 Reviews
HobbyKing
TURNIGY MEGA 400W V2 LITHIUM POLYMER BATTERY CHARGER (VERSION 2)
| Note | Temperature sensor not included. |
| Input voltage | 11.0 – 18.0Volt |
| Charge current | 0.1 – 20.0A |
| Discharge current | 0.1 – 5.0A |
| Maximum discharge capacity | 25W |
| Current drain for balancing Li-po | 200mAh/cell |
| Lithium (LiPo/LiIo/LiFe) battery cell count | 1 – 6 series |
| NiCd/NiMH battery cell count | 1 – 18 series |
| Pb battery voltage | 2 –24V |
| Intelligent temperature control | Yes |
| Weight | 815g |
| Dimensions | 146x144x56mm |
Maximum charge capacity:, 400W @ input voltage >15V, Battery setup memories:10, Note:, Power supply and temperature sensor not included.,
Take advantage of the new high C charge rate on ...5 Reviews
HobbyKing
TURNIGY TALON CARBON FIBER QUADCOPTER FRAME
| Weight | 240g |
| Width | 498mm |
| Motor Bolt Holes | 22~32mm |
Specs:,
If your looking for a high end, no compromise quadcopter ...5 Reviews
HobbyKing
H-KING ATOM MINI GLIDER 750MM W/BATTERY (PNF)
| Wing Span | 750mm |
| Wing Loading | 22g/dm2 |
| Length | 490mm |
| Flying Weight | 145g |
| Servo | 7g x 2 |
| Motor | 180 Brushed |
| ESC | 5A Brushed with BEC |
| Includes | Instructions |
Specs:, Requires:, Your Own 4 Channel TX/RX, * Please Note: The supplied Lithium Ion battery can be charged as a standard Lipoly, 2s Lipoly Batteries are also compatible for use with this model.,
The Hobbyking Atom is a modern, fun Mini Glider injected ...5 Reviews
HobbyKing
HOBBYKING MULTI-ROTOR CONTROL BOARD V3.0 (ATMEGA328 PA)
| Weight | 14.5 gram |
| Gyro | Murata Piezo |
| Input Voltage | 3.3-5.5V |
| Signal from Receiver | 1520us (4 channels) |
| Signal to ESC | 1520us |
Size:, 50.5mm x 50.5mm x 23.5mm, IC:Atmega328 PA, Note:, A user manual is available under the files tab.,
Based on the popular and already well supported KK Control ...5 Reviews
HobbyKing
HOBBYKING DONKEY ST380L-4200KV BRUSHLESS INRUNNER CAR MOTOR (11T)
| RPM/v | 4200kv (11T) |
| Dimensions | 27.6mm x 46mm |
| Shaft | 3mm |
| Voltage | 7.4v~11.1v |
| Weight | 142g |
| No-load current | 2.6A @ 7.4v |
| Max Current | 33A |
| Max Watts | 360W |
Specs:,
When pulling power matters and looks.. well.. just dont, then ...5 Reviews
HobbyKing
HOBBYKING DONKEY ST380L-3600KV BRUSHLESS INRUNNER CAR MOTOR (13.5T)
| RPM/v | 3600kv (13.5T) |
| Dimensions | 27.6mm x 46mm |
| Shaft | 3mm |
| Voltage | 7.4v~11.1v |
| Weight | 140g |
| No-load current | 1.5A @ 7.4v |
| Max Current | 30A |
| Max Watts | 300W |
Specs:,
When pulling power matters and looks.. well.. just dont, then ...HobbyKing
HOBBYKING DONKEY ST380L-3000KV BRUSHLESS INRUNNER CAR MOTOR (15T)
| RPM/v | 3000kv (15T) |
| Dimensions | 27.6mm x 46mm |
| Shaft | 3mm |
| Voltage | 7.4v~11.1v |
| Weight | 138g |
| No-load current | 1.4A @ 7.4v |
| Max Current | 25A |
| Max Watts | 260W |
Specs:,
When pulling power matters and looks.. well.. just dont, then ...3 Reviews
HobbyKing
1/10 CARLSSON C25 CARBON FIBER STYLE CAR BODY SHELL (190MM)
| Length | 460mm |
| Width | 196mm |
| Wheelbase | 260mm |
Note:, Body shell requires finishing such as cutting out of the wheel wells and applying decals., Specs:, Fits:, 190mm 1/10 class on-road car,
This is a high quality "carbon fiber style" polycarbonate body ...HobbyKing
1/10 VIPER SRT10 CARBON FIBER STYLE CAR BODY SHELL (190MM)
| Length | 470mm |
| Max Body Width | 205mm |
| Wheelbase | 260mm |
Note:, Body shell requires finishing such as cutting out of the wheel wells and applying decals., Specs:, Fits:, 190mm 1/10 class on-road car,
This is a high quality "carbon fiber style" polycarbonate body ...HobbyKing
1/10 MUSTANG GT350 CARBON FIBER STYLE CAR BODY SHELL (190MM)
| Length | 470mm |
| Width | 205mm |
| Wheelbase | 260mm |
Note:, Body shell requires finishing such as cutting out of the wheel wells and applying decals. Please see last photo for reference., Specs:, Fits:, 190mm 1/10 class on-road car,
This is a high quality "carbon fiber style" polycarbonate body ...5 Reviews
HobbyKing
1/10 S15 CARBON FIBER STYLE CAR BODY SHELL (190MM)
| Length | 440mm |
| Max Width | 193mm |
| Wheelbase | 260mm |
Note:, Body shell requires finishing such as cutting out of the wheel wells and applying decals., Specs:, Fits:, 190mm 1/10 class on-road car,
This is a high quality "carbon fiber style" polycarbonate body ...5 Reviews