Thunder Power ReadyMadeRC Review

ReadyMadeRC

HITEC H4 DC/DC MULTI-CHARGER 4 PORT MICRO PROCESSOR CHARGER

Stock# 44152	Flight Power/Thunder Power Battery Adapter
Stock# 44153	PolyQuest/HP Battery Adapter
Stock# 44154	Molex EH Balancing Adapter
Stock# 44155	Molex XH Balancing Adapter
Stock# 44178	Universal Balancing Board

Input Voltage Range:, DC 12 - 18 Volts DC, Required Input Amperage:, 40 Amps / 500 Watts, Charger Circuit Power:, , Discharge Circuit Power:, 10 watts x 4 or 20 watts x 2 Using Channel Bridge Function, Charge Current Range:, , Discharge Current Range:, 0.1 - 2.0 Amps per Channel or 0.1 - 4A Using Channel Bridge Function, LiPo,LiFe & LiIon Balancing Current Drain:, 200mA per Cell, LiPo,LiFe & LiIon Cell Count:, 1 - 6 Cells, Maximum NiCd/NiMh Cell Count:, 1 - 15 Cells, Lead Acid (Pb) Cells / Voltage:, 2 - 20 Volts, Dimensions (W x D x H):, 8.1" x 6.4" x 2.0", Weight:, 3.2 lbs,

Its sleek, aluminum design, easy-to-read backlit graphic display and four ...

ReadyMadeRC

RMRC BATTERY VOLTAGE TESTER - WITH AUDIO ALARM LIPO 1-8S

Features:,

An easy to use voltage checker and low voltage alarm ...

ReadyMadeRC

POWERBOXAV AUDIO VIDEO AND POWER DISTRIBUTION BOX

Dimensions	85 x 74 x 23mm
Weight	120 g
Power Requirements	6-12v, 30W max power output
http	//www.readymaderc.com/
http	//www.readymaderc.com/
http	//www.readymaderc.com/
http	//www.readymaderc.com/
http	//www.readymaderc.com/
http	//www.readymaderc.com/
http	//www.readymaderc.com/

Ships with:, 1 x 3 meter 3.5mm -> 3.5mm A/V cable (goggles -> powerbox), There are a variety of cables you can use with the Powerbox. For power, it's the standard 2.1mm barrel connectors:, There are 1 foot cables with female RCA connectors:, There are 1.2meter and 3 meter cables with male RCA connectors:, And also 1.2 and 3 meter cables that have the mini connectors on both ends that can connect between the Powerbox and some of the FatShark goggles and the EZTracker as well:,

Ground-station Companion Today’s ground-station is typically an array of devices, ...

ReadyMadeRC

LC COMMON MODE POWER FILTER

Revision	Rev3 March 2013
Type	passive common-mode low-pass power ripple filter
Modes	common mode, single mode - jumper selectable
Maximum voltage	16V DC
Maximum current	~1.5A
Cutoff frequency at -3dB	127 Hz (attenuates higher frequencies/noise)
Voltage drop over filter	180mV at 900mA
Maximum voltage ripple	120mV
Capacitor	Japanese Polymer Capacitor
Impedance/ESR	0.012 Ohm at 100kHz/16V
Ripple current	5000mA rms
Choke	German Common-mode Choke
Series resistance (DC)	0.205 Ohm/path
Wire / trace thickness	twisted 22 AWG / 32 mils
Operating temperature	-40 °C to +105 °C
Dimensions	37.7 L x 8.8 W x 14.5 H mm
Weight	8.1 grams (inc. JST connectors)

Specifications:,

LC power filter - LPF-01 LPF-01 LC Power Filter This ...

ReadyMadeRC

E-FLITE - POWER METER (EFLA110)

Current Display Range	100mA–120A
Voltage Display Range	4V–50V
Power Display	6000W
Current Resolution	.1A
Voltage Resolution	.1V
Power Resolution	0.1W
Capacity	Up to 9999mAh

Note:, This unit comes pre-installed with EC3 connectors. If you need adapters for T-plugs, you can find them in our,

power adapters section. You can also solder your own connectors ...

ReadyMadeRC

FLYING CINEMA - POWER PACK 30A

Details:, FlyingCinema Power Pack, - This was made so you can reduce your build time to the minimum, all the main components of the dirty section are solder in place and test 100% It comes with: 4 30A SimonK flashed ESCs bench tested 3 JST male connectors 1 Cinecoin 1 XT60 with 12AWG silicon cables ready. (male and female),