RCModelScout.

ReadyMadeRC

BARE WIRE ADAPTER FOR TSLRS V6/V7 TX

,

ReadyMadeRC

DRAGONOSD+ V2 (MAIN UNIT, NO GPS OR CURRENT SENSOR)

ReadyMadeRC

DRAGONLINK 2 LONG RANGE UHF RC SYSTEM

Includes:, 1 Transmitter Module, Notice: The use and operation of this product in the USA and many other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them.  Ready Made RC, LLC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,

ReadyMadeRC

TINY VIDEO SWITCH

Thanks to jannoon028 from RcGroups for this great video :),

ReadyMadeRC

DRAGONLINK FUTABA MINI SQUARE TX CABLE

,

ReadyMadeRC

TSLRS TX600+ UHF TRANSMITTER

Example: 1000mAh / 126mA = 7.9 hrs, remember to keep a good safe margin, some batteryes like LIPO do not like to be fully empty., Notice: The use and operation of this product in the USA and many other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them.  ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,

ReadyMadeRC

FY-901 MULTI-ROTOR FLIGHT STABILIZATION CONTROLLER

The FY-901 for multi-rotor copter can be used in the following models:, , :, , The FY-901 has been tested to work well with the following RC system:, , The FY-901Operating Mode for multi-rotor copter supports two flight modes :, , 1: Auto-Stabilization mode., : 3D Control Mode., Gyroscope initialization (re-setting):, , Out of the box, the FY-901 has been fully initialized. However, if the following condition occurs, resetting the gyro is recommended:, , NOTE:,

ReadyMadeRC

BOSCAM AIO GOGGLES KIT WITH CAMERA AND 5.8 AND 2.4G TX

Includes:, , Manufacturer Specs:, Transmitter frequency:Amateur Radio Band, 5865M, 5845M, 5825M, 5805M, 5785M, 5765M, 5745M, 5725M;8CH;8CH (not frequency-compatible with FatShark, ImmersionRC, or Airwave based equipment), Transmitter frequency:2370-2510MHz; 8CH  (Units shipped to US addresses are locked and include channels at 2414MHz and 2432MHz only, no exceptions!), Notes: These use reverse polarity, RP-SMA connectors and may require an adapter with the use of some antennas. Although ImmersionRC A/V connectors fit, the power/ground will need to be reversed before use., Notice: The use and operation of this product in the USA and other countries may require an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them.  ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,

ReadyMadeRC

BOSCAM GS920 AIO FPV GOGGLES WITH HEAD TRACKER AND 2.4/5.8 RX

Manufacturer Specs:,

ReadyMadeRC

DJI NAZA H - HELICOPTER STABILIZATION CONTROLLER

ReadyMadeRC

DJI NAZA-M V2, MAIN CONTROLLER, PMU LED, NO GPS

Features:, All-in-one Design, It offers three types of control modes: GPS Atti. Mode (with GPS module), Atti. Mode, Manual Mode. The pilot can switch between the three modes to achieve different flight characteristics. It also can adjust automatically within the flight environment and intelligently switch between GPS Atti. Mode and Atti. Mode to make sure the flight is safe and secure. In the software at the position of the manual mode you can choose manual, attitude or failsafe; it supports one key failsafe trigger., Usually, the forward direction of a flying multi-rotor is the same as the nose direction. By using Intelligent Orientation Control (IOC), wherever the nose points, the forward direction has nothing to do with nose direction:, In course lock flying, the forward direction is the same as a recorded nose direction. See the following figures(Mode 2)：, There are four ways to start the motors, see the following picture:, When you want to start the multi-rotor, you need to perform any of the ways of CSC. During the flight, if the motors stop, you can immediately execute the CSC and the motors will start. This enhances the safety of the multi-rotor; no uncontrolled starting of the motors., Note: It has a brand new, smoother take-off algorithm, which is more stable and provides a brand-new experience and supports double spring TX; every time you let go of the throttle stick it will hover., MC:4.8V~5.5V, MC:27g, MC: 45.5mm x 32.5mm x 18.5mm,

ReadyMadeRC

DJI NAZA-M V2 MULTIROTOR AUTOPILOT W/GPS

Features:, All-in-one Design, It offers three types of control modes: GPS Atti. Mode (with GPS module), Atti. Mode, Manual Mode. The pilot can switch between the three modes to achieve different flight characteristics. It also can adjust automatically within the flight environment and intelligently switch between GPS Atti. Mode and Atti. Mode to make sure the flight is safe and secure. In the software at the position of the manual mode you can choose manual, attitude or failsafe; it supports one key failsafe trigger., Usually, the forward direction of a flying multi-rotor is the same as the nose direction. By using Intelligent Orientation Control (IOC), wherever the nose points, the forward direction has nothing to do with nose direction:, In course lock flying, the forward direction is the same as a recorded nose direction. See the following figures(Mode 2)：, There are four ways to start the motors, see the following picture:, When you want to start the multi-rotor, you need to perform any of the ways of CSC. During the flight, if the motors stop, you can immediately execute the CSC and the motors will start. This enhances the safety of the multi-rotor; no uncontrolled starting of the motors., Note: It has a brand new, smoother take-off algorithm, which is more stable and provides a brand-new experience and supports double spring TX; every time you let go of the throttle stick it will hover., MC:4.8V~5.5V, MC:27g, MC: 45.5mm x 32.5mm x 18.5mm,

ReadyMadeRC

TSLRS TX700 UHF TRANSMITTER

,

ReadyMadeRC

NORMAL RANGE 433MHZ RECEIVER NR 700

,

ReadyMadeRC

LONG RANGE 433MHZ RX700 DIVERSITY RECEIVER + PSU (TSLRS)

,