Skip to content

DPCAV

GUARDIAN 2D/3D INERTIAL STABILIZER (STANDALONE MODEL)

Instruction ManualClick Me!
PC SoftwareClick Me!

Q: Why do I need the Guardian?, The Guardian helps both beginner and expert pilots fly with confidence, and provides two key modes of operation: In 2D flight mode, the Guardian provides much smoother flight and wing leveling stabilization for your model, which makes it a lot easier to adjust and fly your plane. The Guardian "remembers" level flight for your model and returns it to level flight when needed, as well as providing precise "fly by wire" control., The Guardian has two submodes for 3D flying: In 3D Heading Lock submode, simply center your sticks to have the Guardian lock onto your present attitude (pitch, roll, and heading), which can make it easier to perform stunts like prop hanging, inverted flight, knife edges, low speed harriers, etc. In 3D Gyro submode, the Guardian uses its built-in 3 axis gyro to increase your model’s stability, while leaving you in full control. In this mode the Guardian greatly reduces the effects of gusts, turbulence, motor torque and other factors, and can expand the maneuverability of your model in a variety of conditions., Q: I Fly FPV. Is the Guardian for me?, Q: Will the Guardian work with my model?, Q: How do I install the Guardian?, Q: How do I configure the Guardian?, Q: How does the Guardian work?, Q: What sets the Guardian apart from other Stabilization systems out there?, *Note: Using the PC software will require a common Micro-USB cable. Most likely you already have one of these, but it not then they are available from your local electronic/computer store.,

Based on Eagle Tree's proven inertial stabilization technology, the Guardian ...

DPCAV

DIGITAL OSCILLOSCOPE, 2-CHANNEL / 10MHZ (PORTABLE)

Analog Bandwidth0 - 10MHz
Sensitivity10mV/Div - 2V/Div
Resolution8-bit
Input Impedance1M ohm
Maximum Input voltage50Vpk (for 1X probe) and 400Vpk (for 10X probe)
CouplingDC, AC, GND
Max Real-time Sampling Rate50MSps
Timebase0.2us/Div - 10 minutes/div
Record Length500 - 8000 points (each channel)
Run/Hold Modesone button switchable
Trigger ModesAuto, Normal, Single
Trigger TypesRising/falling edge
Trigger SourcesCh 1 or Ch 2
Trigger Position0 - 100% of capture buffer
Supply Current300mA @ 3.7V(LCD backlight ON, typical).
Dimension140mm X 70mm X 30mm
Weight190 gram (including battery)
Documents, firmware, and toolsUsers Manual

Portable 2-Channel 10MHz Digital Oscilloscope:, This portable scope offers a lot of features at an affordable price. It has 2-channels with 10MHz analog bandwidth (50msps) and it includes a rechargeable battery pack. Two switchable 10X scope probes are provided too!, The DSO-094 has useful features that are not commonly found in other low cost oscilloscopes. For example: It can be placed in "Persistent Display" mode that keeps waveforms on screen until you erase them; This is very useful when combined with NORMAL trigger mode to capture and compare multiple waveforms that meet your trigger conditions., Features:, , Specifications:, , Number of Channels: 2,

This is a FACTORY ASSEMBLED scope; It is not a ...

ngHobbies

ADJUSTABLE 1AMP STEP-DOWN POWER REGULATOR

Input6-23V
Output3.3V, 5V, 9V or 12V (+/-5%)
Load1000mA max
Efficiency75-85% depending on load
Width17.5mm
Height5mm
Length30.5mm
Weight5 grams

Specifications:, , Dimensions:, Documentation:,

The New Generation Hobbies1A adjustable step down is a state ...

ngHobbies

FATSHARK MIG HEADTRACKER

Features:, Built in gyroscopic sensors, Weight:, 150 gr., Documentation:,

One of the most affordable and most feature rich headtracker ...

ngHobbies

AIRSPEED KIT WITH MPXV7002DP

Weight0.1 oz; 4 g (Just the sensor)

The MPXV7002 is designed to measure positive and negative pressure. In addition, with an offset specifically at 2.5V instead of the conventional 0V, this new series allows to measure pressure up to 7kPa through each port for pressure sensing but also for vacuum sensing (refer to the transfer function in the data sheet for more detailed information). Features: -2 to 2 kPa (-0.3 to 0.3 psi). 0.5 to 4.5 V Output,

This is a stand-alone airspeed sensor. Includes Pitot Tube and ...

ngHobbies

OSD PRO SYSTEM 10HZ GPS, 150A ELOGGER V4 W/ WIRE LEADS

This is a ready to fly package with the following inside:, 1 x e-Logger V4 150A with integrated connectors., Manuals:, eLogger Manual,

Whether you’re into Electric Planes, Helis, Cars, Boats or other ...

ngHobbies

MICROPOWER E-LOGGER WITH INTEGRATED CONNECTORS (V4)

Manuals:, eLogger Manual,

Whether you’re into Electric Planes, Helis, Cars, Boats or other ...

ngHobbies

MICROPOWER E-LOGGER WITH WIRE LEADS 150A(V4)

Manuals:, eLogger Manual,

Whether you’re into Electric Planes, Helis, Cars, Boats or other ...

ngHobbies

MICROPOWER E-LOGGER WITH WIRE LEADS 100A(V4)

Manuals:, eLogger Manual,

Whether you’re into Electric Planes, Helis, Cars, Boats or other ...

ngHobbies

MICROPOWER E-LOGGER WITH INTEGRATED CONNECTORS (V3)

Manuals:, eLogger Manual,

Whether you’re into Electric Planes, Helis, Cars, Boats or other ...

ngHobbies

OSD PRO SYSTEM 10HZ GPS 100A ELOGGER V4 W/ INTEGRATED CONNECTORS

This is a ready to fly package with the following inside:, 1 x e-Logger V4 100A with integrated connectors., Manuals:, eLogger Manual,

Whether you’re into Electric Planes, Helis, Cars, Boats or other ...

ngHobbies

OSD PRO SYSTEM 10HZ GPS, 100A ELOGGER V4 W/ WIRE LEADS

This is a ready to fly package with the following inside:, 1 x e-Logger V4 100A with wire leads., Manuals:, eLogger Manual,

Whether you’re into Electric Planes, Helis, Cars, Boats or other ...

ngHobbies

5V 1A PSU FOR LAWMATE 500MW TRANSMITTERS V2

Input6-23V - reverse polarity protected
Output5V +/-5% - improved output voltage stability on higher loads
Load1000mA max
Efficiency85-90% depending on load
Width24mm, Height
Weightless than 5 grams

Features:, Specifications:, : Minimal assembly and soldering required., Documentation:, Please click the following link for the manual:, Utilization and assembly manual, :, Click here to read, This product is:, Made in Canada,

This new version 2 of the very successful 5V 1A ...

ngHobbies

100MW 5.8GHZ FATSHARK TRANSMITTER

Operating Frequencies5740, 5760, 5780, 5800, 5820, 5840, 5860MHz
Weight20 grams
Size57 x 34mm
Input voltage range6 - 16 v

Parameters:, 100mW output power, Content of the package:, 1 x 100mW Transmitter module, Note:, The use and operation of this product in most states, countries may require a HAM or Amateur radio license. New Generation Hobbies cannot be held responsible for your actions if you use this product without proper licensing.,

The Fatshark 5.8Ghz 100mW transmitter is a state of art ...

ngHobbies

25MW 5.8GHZ IMMERSIONRC TRANSMITTER

Operating Frequencies5740, 5760, 5780, 5800, 5820, 5840, 5860MHz
Weight20 grams
Size57 x 34mm
Input voltage range6 - 16 v

Parameters:, 25mW output power, Content of the package:, 1 x 25mW Transmitter module, Note:, The use and operation of this product in Canada and United States will require a HAM or Amateur radio license.  Please check with your local authorities before purchasing this product.,

The Immersion RC's 5.8Ghz 25mW transmitter is a state of ...

BevRC DPCAV Hobby-Lobby HobbyKing LowPriceRC ngHobbies NitroTek R2Hobbies RangeVideo RCTimer ReadyMadeRC HobbyWireless RCPlanet HorizonHobby HiModel OFM GetFPV AMainHobbies SDSHobby GoodLuckBuy Flying-Hobby