HobbyWireless
R1200-STD 1.2 GHZ HIGH SENSITVITY RECEIVER STANDARD - LAWMATE
| - Operating voltage | Vcc, 10.5V (minimum), 12V (typical), 13V (maximum). |
Details:, This receiver is part of the success of our wireless systems., Channels:, , Switch to A:, ,
The sensitivity is a very important point, giving the wireless ...HobbyWireless
R5800DX DUO 5.8 GHZ DIVERSITY RECEIVER - 2 IN1 FOR DOUBLE RECEPTION
| - 8 Selectable channels | DIP switches (4 switches for each built-in receiver) |
| - Working Frequencies | CH1 |
| - Working voltage | 8-12 VDC (runs cooler with 8V) |
| - Receiving sensitivity | < -90dBm |
| - Receiving frequency | ISM 5.8GHz 8CH |
| - Antenna port | 50ohm SMA |
| - Antenna | Gain |
| - Power supply | DC12V 220mA |
| - Video output level | 1Vp-p @ 75ohm |
| - Audio output level | 1Vp-p @ 10Kohm |
| - Dimensions | 76 x 64 x 18 mm |
| - Current consumption | 120mAh |
| Receiver 1 Channel setup | DIP switches 1 2 3 |
| Receiver 2 Channel setup | DIP switches 4 5 6 |
Details:, The R5800DX Duo receiver was developed not only improve the reception quality and range but also to have better coverage., Note:, If your transmitter was purchased before October 2012 it may no be compatible with the R5800DX Duo Diversity Receiver.,
Another great advantage of this receiver is to be able ...HobbyWireless
TR524 COMBO SET RECEIVER +TRANSMITTER 2.4GHZ 500MW - LAWMATE
Details:, , Note: The 2.4GHz video system can not be used with any 2.4Ghz radio transmitter, it migh cause severe interferences., Package Includes:, , Transmitter Specs:, , Receiver Specs:, , Note:, All transmitters shipped to any addresses within US territory will have only the Channel 1 (2410 MHz) available., Disclaimer:, Hobby Wireless is not responsable any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility.,
This is a great set of 500mW 2.4 GHz transmitter ...HobbyWireless
TR1012 COMBO SET RECEIVER +TRANSMITTER 1.2GHZ 1000MW - LAWMATE - ALSO AVAILABLE TO USA CUSTOMERS
| The system can be powered using any DC power source from 10.5 to 13 volts DC example | 3 cells lithium polymer battery works great. |
Details:, Do you want a powerful wireless systems that gives you more than 3 miles of range?, It's perfect for long range applications, (for RC models: it is recommended to install the transmitter as far as possible away from the model's receiver) Even with all this power it only weights around 1oz 30 grams ., Package includes:, -Transmitter 1.2ghz 1000mW with RCA cable for audio and video input., Transmitter Specs:, -1000mW RF output power 1.2GHz frequency band, Receiver Specs:, - Operating voltage from 10.5 to 13 volts DC - 240mA power consumption, Notes:, All transmitters shipped to any addresses within US territory will have only the Channel 8 (1280 MHz) available. In order to use it within USA an, Disclaimer:, Hobby Wireless is not responsible any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility., Avoid Permanent Damage:, Before applying power to your transmitter and receiver, double check for correct polarity. Also make sure the power source doesn't exceed 13.5 VDC which will not be covered by the warranty.,
Then, this is what you are looking for. This transmitter ...HobbyWireless
HYPERION BULLET SAFETY NUT TO FIT PROP ADAPTERS WITH M5 SHAFT
Details:, , Product Description:,
Bullet Safety Nut to fit prop adapters.HobbyWireless
APC 9 X 3.8 SLOW FLYER PROPELLER
Details:, , Description:, APC 9 X 3.8 SLOW FLYER PROPELLER,
HobbyWireless
APC 10 X 4.7 SLOW FLYER PROPELLER
Details:, , Description:, APC 10 X 4.7 SLOW FLYER PROPELLER,
HobbyWireless
BAROMETRIC ALTITUDE AND TEMPERATURE SENSOR FOR DRAGONOSD V2
Details:, Micro barometric altitude and temperature sensor for the DragonOSD., Specifications:, 0.1hPA/ 0.1C resolution, Very important note from the developer:, , I2C is a very popular communication bus. It has two signal lines: clock (SCL) and data (SDA). In a normal I2C circuit, each of these lines is connected to each I2C component on the bus as well a pull-up resistor (usually somewhere between 4k and 10k). I2C doesn't to my knowlege stricly define what voltage that pull-up value is but each component has limits on what it can handle. For example, the BMP085 barometer maxes out at 3.6v., So there are a few possible fixes:, The one what we have been discussing in the last few posts: run ArduIMU on 3.3v throughout. You still get extra pull-ups but at least the pull-up is to a safe 3.3v. To do this, put 3.3v on 5V pin on the FTDI connector and on the 3.3V I2C bus connector., The other way to fix this is that an ArduIMU updated firmware could be developed that modifies these lines in twi.c to turn off the pull-ups:, , So ArduIMU users: before you add 3.3v sensors to your bus, check their tollerances and make this update if they can't handle 5V.,
Pin header is included as optional pass-through for other I2C ...HobbyWireless
32GB KINGSTON SD MEMORY CARD CLASS 4
| Capacity | 32 GB |
| Weight | 0.09 oz (2.5 g) |
| • Warranty | Limited Lifetime |
Details:, , Type:, secure digital high-capacity, Write Speed:, minimum 4 MBps (class 4), Dimensions:, 1.27" x .94" x .08"/3.23cm x 2.39cm x .20cm (H x W x D), What's Included:, ,
The Kingston® 32GB Secure Digital High-Capacity (SDHC) memory card combines ...HobbyWireless
T905 TRANSMITTER 900 MHZ 500 MW
Details:, It's not the same cheap technology sold over the internet. With this transmitter you will get what you pay for., Channels:, , Transmitter Specs:, -RF Output Power 500 mW, Note:, All transmitters shipped to any addresses within US territory will have only the Channel 1 (910 MHz) available., Disclaimer:, Hobby Wireless is not responsable any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility.,
It uses PLL technology, very tiny and so light weight ...HobbyWireless
FATSHARK BATTERY CHARGER
Details:, This is a replancement charger for FatShark Aviator video glasses, and it can also be used to charge Dominator's video glasses battery.,
This is an US version, it can be used in ...HobbyWireless
FATSHARK - EARPHONES WITH VOLUME CONTROL SLIDERS.
Details:,
Fatshark Earphones with Volume Control Sliders. Compatible with Fashark video ...HobbyWireless
FAT SHARK BASE SD VGA VIDEO GLASSES
| FOV (field of view) | 35°diagonal (Image size |
| Interpupillary (IPD) distance | 59 – 69 mm (adjustable) |
| Supports optional diopter lens inserts | -2, -4, -6 dpt |
| User Controls | Contrast/ brightness control |
| Power supply | 7 - 13 V (2S/3S Lipo Battery) |
| Power consumption (@7.4V nominal) | 150mA |
Details:, Built for serious FPVer’s, the new BASE SD goggle is the only choice for tethered video piloting., Headset Specifications:, , Optics:, Audio:, Stereo (requires adjustable volume earphone accessory), Electrical:, Mechanical:, Ergonomic molded headset w/ adjustable headband, Weight:, 120g (not including cable), Display:, Full color LCD LED backlit Kopin CyberDisplay, Head Tracker:, None, Interface:, Futaba Square 6pin AV in port (Vin, GND, AudR, AudL, Vid),
The BASESD has dedicated tooling for a smaller, sleeker profile ...HobbyWireless
DIOPTER LENS SET FOR FATSHARK VIDEO GLASSES - 2.00, - 4.00, - 6.00
Details:, A set of, Package contains:,
- 2.00, - 4.00, - 6.00 diopter lenses to attach ...HobbyWireless
2S 7.4V 1000MAH LIPO BATTERY FOR FATSHARK VIDEO GLASSES
Details:, This is the new Fatshark 7.4v 1000mAh Lipo battery for Fatshark video glasses Aviator, Base, Predator, Dominator. Includes discharge lead adapter (required by some chargers).,