GetFPV
TIGER MOTOR 20 AMP ESC
| Output | Continuous 20 amps, burst ~22 amps up to 10 Seconds |
| Input Voltage | 2-4 cells Lipo battery or 5-12 cells NiCd/NIMh battery |
| BEC | 2A / 5V (Linear mode) |
| Size | 35mm (L) * 29mm (W) * 8mm (H) |
| Weight | 24g |
| Multiple protection features | Low-voltage cut-off protection / over-heat protection / throttle signal loss protection |
| 3 start modes | Normal / Soft / Super-Soft, compatible with fixed-wing aircrafts and helicopters. |
GetFPV
TIGER MOTOR MN-4012 + 4014 SERIES BEARINGS
,
Details Tiger Motor upper and lower replacement bearings for the ...GetFPV
10.1" LUMENIER LCD MONITOR - LED BACKLIT
| Image | 10.1" TFT LCD LED Backlit |
| Resolution | 1366x768 |
| Horizontal frequency range | 30-98KHz |
| Field frequency range | 60-75Hz |
| Brightness | 450cd/m² |
| Viewing Angle | 70°/70°(L/R) 40°/50°U/D |
| Contrast Ratio | 500 |
| Response time | 8ms |
| Input Voltage | DC 12V ~ 15% |
| Power Consumption | ≦10W |
| Input Singal | VGA,AV1,AV2,Audio,HDMI |
| Size | 255L×163W× 34D mm |
| Weight | 544g without cables or sun shield, 875g with cables and sun shield |
| Mounting | Standard 1/4-20 tripod and VESA mounts |
Display Ratio: 16:9,
Details This FPV monitor is a large 10.1" super bright ...GetFPV
TIGER 15X5 CARBON FIBER PROPS (PAIR)
,
Details Tiger Matched Pair props are specially designed for multi-rotors. ...GetFPV
METAL LUMENIER CAMERA CASE
,
Details This Lumenier branded metal housing fits ours popular CS-600 ...GetFPV
LUMENIER CU-690 ULTRA - 690TVL ULTRA WDR
| Power input | DC12V |
GetFPV
DJI NAZA M V2 GPS/COMPASS
,
Details High quality GPS for your multi-rotor for direct integration ...GetFPV
LUMENIER 30 AMP ESC WITH SIMONK FIRMWARE
| Max continuous load | ~23 amps |
| BEC | 5v/3amps max |
| Lipo Cells | 2 to 4 cells |
Simon had this to say about the new Lumenier SimonK ESCs:, These ESCs are a revision of the nearly-perfect F-30A ESCs with high quality board layout and components.,
Details Jointly developed with SimonK himself, this is Lumenier's rendition ...GetFPV
TIGER MOTOR M6 CCW PROP ADAPTER NUT FOR MT-3515 MOTORS
,
Details One 6mm Counter Clockwise Thread Nut/Prop Adapter for MT-3515 ...GetFPV
QAV540G GIMBAL PARTS & HARDWARE
,
Details The gimbal parts and hardware required to assemble. This ...GetFPV
12V STEP-DOWN VOLTAGE REGULATOR
| Maximum output current | 600 mA |
| Small size | 0.5″ × 0.4″ × 0.1″ (13 mm × 10 mm × 3 mm) |
Input voltage: [,
Details This micro sized step-down voltage regulator is perfect for ...GetFPV
QAV400 FPV QUADCOPTER FRAME ARF
| Weight | 375g (without landing gear) |
| AUW | 1165g with 2250mah 4s lipo, gopro3, flight cam, TX, and CC3D board |
| Flight Time | 10 minutes hover with Lumenier 2250mAh 4s, 12-15 minutes on Lumenier 4s 3300mAh |
| Body | G10 |
| Booms | Anodized machined Aluminum |
Power: Like the QAV500, the QAV400 comes with a power distribution board to solder the ESCs to as well as the FPV electronics, Max Lipo Dimensions: W: 54mm, H: 35mm, L: 150mm,
Details The new QAV400 FPV Quadcopter is nimble acrobat that ...GetFPV
X8R 16CH RECEIVER, SBUS, SMART PORT - AMPLIFIED PCB ANTENNA
| Dimension | 46.5mm x 27mm x 14.4mm (1.83" x 1.06" x .56") |
| Weight | 16.8g (.59 oz) |
| Operating Voltage Range | 4V-10.0V |
| Operating Current | 100mA@5V |
| Operating Range | >1.5km (Full Range) |
| RSSI output | analog voltage output (0~3.3V) |
Specification:, Compatibility:, All 16 channels requires the FrSky Taranis, or the XJT module.,
Details FrSky's newest receiver features 16 channels (8 normal pwm ...