RCModelScout.

HobbyKing

RCG 20CC GAS ENGINE - CYLINDER

,

HobbyKing

DM-33 GAS ENGINE W/CD-IGNITION 3.8HP/33CC

Engine type:, single cylinder, 2-stroke, air-cooled, Carburetor:, Tillotson choke type/diaphragm carburetor, Start mode:, Anticlockwise Push Prop Start, Dimensions:, 185x80(115)x160(210) mm,

HobbyKing

GAS ENGINE CDI IGNITION TEST AND TIMING SETUP TOOL - INCLUDES CRANKSHAFT DEGREE WHEEL

This tester can be used in two ways:, 1. It enables the safest possible way to check for interferance between your CDI Ignition and radio systems, without the need to have your engine running. The unit fires your ignition system at the rpm you set on the units dial to simulate the ignition as if the motor is running, the units RPM range is 400-18000Rpm.,

RCPlanet

TRAXXAS HEADER SPRING/GASKETS TRX 3.3 TRA5254

, ,

RCPlanet

TRAXXAS ENGINE MOUNT COMPLETE ASSEMBLY REVO TRA5360

, ,

RCPlanet

THUNDER TIGER PRO .12BK W/ROTARY CARB TTR9459

, Displacement:, .129 cu in (2.11cc), Bore:, 0.545" (13.85mm), Stroke:, 0.551" (14.0mm), Practical RPM:, 3,000 - 30,000, Output:, 0.60 HP @ 29,000 rpm, Weight:, 8.28oz (234g), Carburetor Settings, Needle Valve:, 2-1/2 - 3 turns counterclockwise from closed, Air Bleed Screw:, After setting needle valve, 1/8 turn clockwise if mixture is too rich or 1/8 turn counter-clockwise if mixture is too lean, Height from Mounting Tab Bottom/Top of Cylinder Head:, 2.7" (68.3mm), Height from Crankcase Bottom to Top of Cylinder Head:, 3.1" (80mm), Width at Mounting Tabs:, 1.6" (39.5mm), Width of Crankcase below Mounting Tabs:, 1" (25.4mm), Center of Mounting Holes Same Side:, 0.43" (11mm), Center of Mounting Holes Opposite Side:, 1.2" (32mm), Center of Crankcase to Front Bearing:, 1.3" (34.5mm), Distance from Shaft Starter to Front Bearing:, 2.6" (66mm), Note:, The carburetor is preset from the factory and requires only small adjustments, ,

HobbyKing

SULLIVAN ONBOARD SMOKE PUMP 6~12V W/ ESC

HobbyKing

TURNIGY BELT DRIVE STARTER FOR 2-STROKE 160 & 110 SIZE GAS ENGINES

Engine class:, Airplane 2-stroke 160 class /Heli 2-stroke 110 class, *Note:, Do not use more than 18V,

HobbyKing

REPLACEMENT CDI FOR TURNIGY HP-50CC CM-6 PLUG

,

HobbyKing

TURNIGY HP50 50CC GAS ENGINE 5.5HP

Thrust:, 13.6kg @ 100mtr / 11.5kg @ 1800mtr (Above sea level), Suggested prop:, 20x8-10 ~ 22x8-10 or more!, : 7.5:1, : 2 Stroke oil/fuel mix (30:1 - 45:1),

HobbyKing

HEADER TANK ASSEMBLY FOR ALL 30-90 SIZE HELI (PLASTIC HOLDER)

,

HobbyKing

XY REPLACEMENT INTAKE MANIFOLD (26CC)

,

LowPriceRC

ASTRAL ADJUSTABLE ENGINE MOUNTS (ROUND BASE) D80X130 13.5X12.5X116MM SET

,

HobbyKing

SULLIVAN MULTI CYLINDER ONBOARD GLOW DRIVER (5 CYLINDER ENGINES)

Features:, Manual or Auto Operation,

HobbyKing

SULLIVAN MULTI CYLINDER ONBOARD GLOW DRIVER (4 CYLINDER ENGINES)

Features:, Manual or Auto Operation,