ReadyMadeRC
900MHZ 1500MW* TRANSMITTER - INTL VERSION 2
| Weight of transmitter with heat sink case, not including wires or antenna | 87g |
| Weight with bare module without heat sink, not including wires or antennas | 37g |
| bare module dimensions | 70*37*7mm |
Notice: The use and operation of this product in the USA and other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
High quality 1.5W* 900MHz transmitter. Not the cheap copies available ...ReadyMadeRC
2.3GHZ "TRUEWIRED" PRO RHCP OMNI PACKAGE (2245-2370MHZ)
,
Whip replacement CP antennas, a Windmill(Tx) matched with a Fan(Rx). ...ReadyMadeRC
VAS - 2.4 GHZ BLUEBEAM WHIP ANTENNA SET RHCP - STRAIGHT
| Contains TWO antennas | 3 lobe TX, and 4 lobe RX |
| Max speeds without significant deflection | 110 mph |
| Connector type | SMA male straight. RIGHT ANGLE ADAPTER INCLUDED! |
| Whip length | 2″/5cm |
Radiation pattern:,
The Blue Beam antenna set is a direct fit circularly ...ReadyMadeRC
2.4 GHZ 14 DBI FLAT PANEL PATCH ANTENNA - 4FT SMA MALE
,
Compact size, 8.5" Square with low-loss coax cable Durable UV-stable, ...ReadyMadeRC
900MHZ RECEIVER WITH UPGRADED SAW FILTER
| CH1 | 910 |
| CH2 | 980 |
| CH3 | 1010 |
| CH4 | 1040 |
ReadyMadeRC
900MHZ-1.3GHZ RECEIVER SAW W/1258 CUSTOM RMRC VERSION 3
| CH0 | 910MHZ |
| CH1 | 980MHZ |
| CH2 | 1010MHZ |
| CH3 | 1040MHZ |
| CH4 | 1080MHZ |
| CH5 | 1120MHZ |
| CH6 | 1160MHZ |
| CH7 | 1200MHZ |
| CH8 | 1240MHZ |
| CH9 | 1280MHZ |
| CHH | 1320MHZ |
| CHC | 1360MHZ |
| CHd | 1258MHZ |
| CHE | 1100MHZ |
| CHF | 1140MHZ |
These receivers were custom-modified specifically to Ready Made RC, LLC specifcations! Lots of great improvements over the standard units including:, Additional frequency that's legal for US use!*, Channels:, *Special note for Scherrer LRS or EZUHF users: Although additional filtering has been added to these receivers to increase their tolerance of UHF signals, it is still recommended that you maintain distance between your UHF transmitter and this receiver. Other websites selling unmodified versions of this receiver claiming theirs are UHF tolerant have NOT fully tested the equipment with all UHF systems. If you have a UHF system and one of those receivers, just put your UHF system in front of your patch antenna and see what happens.,
Additional frequencies added to increase compatibility with Lawmate and other ...ReadyMadeRC
CINEMIZER OLED VIDEO GLASSES
| 24 Bit RGB color depth- FoV (Field of View) | 30° |
| HDMI | 720p, 1080p and 3D (Frame Packing) |
| AV-In | 3,5mm / 4pin jack for audio & video (PAL/NTSC) |
| Battery-Box | 60 g, HDMI-Adapter 30 g |
It's Time to Upgrade:, It's time to move up to the most advanced and highest quality video glasses available for FPV! With features not seen in other popular FPV goggles such as diopter adjustment (for individuals that wear glasses), ear slider for comfort, and high resolution OLED displays, these are sure to be the new favorite for FPV'ers everywhere!, Display adjustments including:, , Aspect ratio 16:9,
The lightweight and compact Cinemizer OLED is packed with engineering ...ReadyMadeRC
1.3GHZ 300MW TRANSMITTER - NEW CUSTOM READYMADERC US VERSION
| CH1 | 1258 MHz |
| CH2 | 1280 MHz |
| Power requirements | 12V, 500mA |
| Weight | 30g (transmitter and antenna, no cables) |
Frequencies:, , Notice: The use and operation of this product in the USA and other countries may require an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
WE'VE OPENED UP A WHOLE NEW FREQUENCY FOR LEGAL USE ...ReadyMadeRC
200MW 1300MHZ TRANSMITTER - NEW CUSTOM READYMADERC INTL VERSION
| Weight with bare module and antenna | TBD |
*Notice: The use and operation of this product in the USA and other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
WE'VE OPENED UP A WHOLE NEW FREQUENCY FOR LEGAL USE ...ReadyMadeRC
AIRSPEED MICROSENSOR V3
| Circuit Board | Weight 4 grams (0.15 oz), dimensions 28 mm x 16 mm x 10 mm (1.1” x 0.62” x 0.4”) |
ReadyMadeRC
900MHZ 800MW* TRANSMITTER - US VERSION
| Weight with case and antenna | 3.4oz. |
High quality 800mW* 900MHz transmitter. Not the cheap copies available on eBay and from other overseas sources. Although the manufacturer calls this an 800mW transmitter, and other retailers sell it stating it's that power level, they actually put out a measured 650mW of power (including the ones from the other vendors). We take the time to verify the ratings from the manufacturers. Do the other dealers? :), Notice: The use and operation of this product in the USA and other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
Comes with heat sink as shown, which can be removed ...ReadyMadeRC
900MHZ 800MW* TRANSMITTER - INTERNATIONAL VERSION
| Weight with case and antenna | 3.4oz. |
High quality 800mW* 900MHz transmitter. Not the cheap copies available on eBay and from other overseas sources. Although the manufacturer calls this an 800mW transmitter, and other retailers sell it stating it's that power level, they actually put out a measured 650mW of power (including the ones from the other vendors). We take the time to verify the ratings from the manufacturers. Do the other dealers? :), Notice: The use and operation of this product in the USA and other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
Comes with heat sink as shown, which can be removed ...ReadyMadeRC
900MHZ 500MW TRANSMITTER - INTL VERSION
| CH1 | 910 |
| CH2 | 980 |
| CH3 | 1010 |
| CH4 | 1040 |
| Power requirements | 12V, 500mA |
Frequencies:, , Notice: The use and operation of this product in the USA and other countries may require an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
INTERNATIONAL VERSION, CANNOT SHIP TO A US ADDRESS UNDER ANY ...ReadyMadeRC
G-FORCE MICROSENSOR - HIGH G SENSOR
| Resolution | approx. 0.05 G in each axis |
| Power input (Standalone Mode) | 4V to 16V (6V max for High G Sensor) |
| Weight | approximately 4 grams (0.15 oz) |
| Dimensions | approximately 28 mm x 16 mm x 10 mm (1.1” x 0.62” x 0.4”) |