ReadyMadeRC
GAUI 330X 10” PROPS. (10A AND 10B)
,
Counter rotating set of 4 10x4.5 props for extended frame.ReadyMadeRC
ALUMINUM CARRYING CASE FOR GAUI 330X QUADFLYER
Outside Dimensions | 14.5" W x 19.5" L x 7" D |
Foam Insert Depth | 3.5" |
Please note: Due to the raised aluminum ribs, these cases may have some minor cosmetic blemishes in the raised ribs and side panels. In fact, you will have to look closely to see any blemishes as they are difficult to photograph and barely noticeable unless the light is right. These are considered normal. Only large dents will be considered unacceptable for return purposes.,
These aluminum cases have a fitted foam insert specially designed ...ReadyMadeRC
GAUI GU-INS MULTI-ROTOR STABILIZER WITH GPS
1. Dimensions | Main controller |
GPS antenna | 42 x 34 x 15mm |
Weight | Main controller |
2. Frequency | 400Hz output to ESC |
3. Operating temperature | -20~80°C |
4. Operating modes | Rate (manual) mode, Auto balance mode, GPS positioning mode. |
5. Rate (manual) mode | Max angular velocity |
6. Auto balance mode | Max tilt angle |
a. Hovering accuracy | Horizontal |
b. Max yaw angular velocity | 250 degree/sec |
c. Max tilt angle | 45 degree. |
d. Max horizontal speed | 10 m/s,36 km/hr |
e. Max vertical speed | 8 m/s (horizontal posture) |
9. Fail-safe functions | Automatic Go-Home, Signal lost Go-Home, Low voltage protection. |
10. Suitable wind condition | < 10 m/s |
Features:, , Specifications:, 7. GPS positioning mode:,
GAUI GU-INS supports X-type flying Quad-copter (GAUI 330X, 500X, etc…). ...ReadyMadeRC
RMRC-700XV 700TVL ATR CCD (NTSC)
Pixels | xxxxx |
ReadyMadeRC
GAUI 500X QUAD COMBO W/SCORPION MOTORS, ESC, GU-344, BAG, FRAME
Dimension | (64) |
Dimension | (?) |
500X was designed based on UAV, advantages are:, , 1. Flight Efficiency: Standard Battery (2S2000mAh) time of flight for more than 12min, with a high-capacity battery, the flight time will be 20 min or more (available spreadsheet calculation), 2. Excellent wind resistance: the efficiency and load of propeller are perfectly optimized, so the wind resistance will be better than general electric aircraft, 3. High stability: When using GU-344 (three-axis stabilizing system) for the beginner or professional in combination with other electronics for FPV flying; making the GAUI Quad Flyer a very stable vehicle., 4. Additional payload capabilities: Maximum Flying Weight is between 1100g to 2200g depending on power system used (330X GAUI Motors/ESCs or 500X GAUI Motors/ESCs), you can install cameras and video recorder, and other system., Note: For users who have transplanted GAUI 330X / 330X-S power systems (motors, ESCs) to the 500X Upgrade kit, please use 8 inch propellers., Powered by:, , : type, Product packing:, , Export Carton (LNK):, , Manual:, , * The payload calculations and the battery options :, Ex 1: If the 500X carries a HD Camera (weight 350g) and uses a 3S/2000mah LiPo(weight 150g),the flying weight is 1170g (670+350+150).The power consumption in this condition is 141w(as table above).The Power of this battery is 11.1(V) * 2(A) * 60(Min.) = 1332.The flying time is about 7.1(Min.)Calculation : (1332 / 141) * 75%(Bat. Factor) = 7.1 (Min.) Ex 2: If the 500X uses 2pcs of 3S/2000mah LiPo(in parallel), the flying weight is 1050g (670+350+ 150X2).The power consumption in this condition is 167w(as table above).The total Power of the batteries is 11.1(V) * 2(A) * 60(Min.) * 2 (Bat. in parallel)= 2662.The flying time is about 12(Min.) Calculation : (2662 / 167) * 75%(Bat. Factor) = 12 (Min.)", CAUTION : The Power Consumption Table is calculated based on cruising, the ESC output current may increase 3 or 4 times more for flying mode other than cruising due to increased power output. Make sure to check flyin,
CAN NOT BE BACK-ORDERED 500X Quad Flyer Combo Kit (Including ...ReadyMadeRC
5.8GHZ LONG RANGE OMNI "HORIZON"
A pair of "Fan" antennas stacked with a phasing coax network. It have an exceptional axial ratio in all directions. Its main lobe follow horizon, making it a premium choice for ground based FPV or low altitude/long range such as multi-copters/gliders. Can be used on Transmitter or Receiver. Gain: 4.5 dbic SWR: <1.3:1,
ReadyMadeRC
1.2-1.3 GHZ GATLING (TRC)
The "Gatling" is the ultimate FPV antenna, like its name implies, it blast trough everything. Light weight and of relatively compact size it can be mounted on most trackers (Our trackers with HS645MG servos work well). Beware, your UHF is now your weakest link! Optimized for 1280MHz Gain: 16 dbic Beamwidth: 62deg. Beamwidth @-3db: 30deg. Axial ratio: 1 Dimensions: 16" x 16" (40.6cm x 40.6cm) Weight: 1.5lb (680g),
ReadyMadeRC
HERO2 HDMI CABLE
What's Included:, , Restrictions:, According to GoPro policy, sales of the GoPro cameras from this store are restricted to the United States only.,
Use this Micro HDMI cable to plug your HERO2 camera ...ReadyMadeRC
CAMERA PAN AND TILT KIT
Manual | Pan/Tilt Module |
Note: careful routing of camera wiring is required to prevent binding during 180 degree or 360 degree operation., Comes with a mounting plate that will fit many popular FPV cameras including:, , Note: Currently the back plates are designed for the pan/tilt system being installed on top of the aircraft. If you plan on mounting the assembly inverted under the aircraft, some modifications to the back plate may be required., This kit includes:, , Note: for the "no servo" option, it is up to the customer to modify the assembly if required. The system was designed for the servo options listed below. Any other servo must be aligned properly for proper gear engagement., You'll need to supply:, ,
This is a stand alone pan/tilt FPV module that uses ...ReadyMadeRC
RMRC-420XV 420 LINE 5-15V CCD CAMERA (PAL)
PAL | 500 x 582 |
PAL | 625 Lines 50 Fields/Sec |
ReadyMadeRC
FLAT ADHESIVE MOUNTS
* Warranty | One Year |
What's Included:, * 5 Flat, 3M Adhesive Mount, Restrictions:, Sales of the GoPro equipment from my store are restricted to the United States only.,
This is the same mount already included with many HERO ...