ngHobbies
EM-406/UBLOX/MTK ADAPTER CABLE 5CM
,
This is a communication cable, 5 centimeters, that mates with ...ngHobbies
HMC5883L - TRIPLE AXIS MAGNETOMETER
Features:, I2C interface with I2C translator for 5V signals compatibility 2.5 to 3.3V and 4V to 5.5V supply range (one at time, jumper selectable) Low current draw 4.35 milli-gauss resolution ArduIMU+ and ArduPilotMega Shield pin compatible., :, Click here,
This is a 3-axis digital compass board based on the ...ngHobbies
3DR RADIO TELEMETRY KIT - 433 MHZ
The 3DR Radio telemetry system is designed as an open source Xbee replacement radio set, offering a lower price, longer range (approx one mile) and superior performance to Xbee radios. It’s available in 915Mhz and 433Mhz; and in the following configurations: serial board (for the air) and USB (for the ground)., Documentation and Manuals:, 3DR Radio Configurator,
The system provides a full-duplex link using HopeRF's HM-TRP modules ...ngHobbies
900MHZ ANTENNA RP-SMA
Length | 107mm |
Gain | 2dbi |
Type | tilt swivel rubberduck |
ngHobbies
MEDIATEK MT3329 GPS V2.0
High sensitivity | Up to -165dBm tracking, superior urban performance |
Maximum update rate | up to 10Hz (optional by firmware) |
Support AGPS function ( Offline mode | EPO valid up to 14 days ) |
Weight | 0.33oz; 9.45 g |
Resources:, -DataSheet,
This revision features a new board layout with an improved ...ngHobbies
PPM DECODER BOARD
Manual, Datasheet:, , : 30x24mm,
PPM Decoder module This board was designed for those who ...ngHobbies
3DR PIXHAWK AUTOPILOT W/O GPS AND PPM ENCODER
• Weight | 38g (1.31oz) |
• Width | 50mm (1.96") |
• Thickness | 15.5mm (.613") |
• Length | 81.5mm (3.21") |
Note: Pixhawk is a PPM-input autopilot, which means that it gets RC input from a single cable to the receiver, either via the PPM port, the Futaba S.BUS port, or the special satellite receiver port for Spektrum gear. Most modern RC receivers (and all those sold by 3D Robotics) allow for PPM output, but some, such as non-S.BUS Futaba receivers, do not., Pixhawk includes:, • Pixhawk autopilot, Microprocessor:, • 32-bit STM32F427 Cortex M4 core with FPU, Sensors:, • ST Micro L3GD20 3-axis 16-bit gyroscope, Interfaces:, • 5x UART (serial ports), one high-power capable, 2x with HW flow control, Power System:, • Ideal diode controller with automatic failover, Weight and Dimensions:,
Pixhawk is an advanced autopilot system designed by the PX4 ...