ReadyMadeRC
Pro Camera Pan and Tilt Kit
| Manual | Pro Pan/Tilt Module |
Note: careful routing of camera wiring is required to prevent binding during 180 degree or 360 degree operation., Note: Currently the back plates are designed for the pan/tilt system being installed on top of the aircraft. If you plan on mounting the assembly inverted under the aircraft, some modifications to the back plate may be required., This kit includes:, , Note: for the "no servo" option, it is up to the customer to modify the assembly if required. The system was designed for the servos listed in the options below. Any other servo must be aligned properly for proper gear engagement., You'll need to supply:, ,
This is the new carbon reinforced plastic pan/tilt FPV module that uses a custom mechanism allowing for full 180 degree (+/- 90 degree) panning with a standard servo without the need for a servo stretcher. A full 360 degree pan (+/- 180 degrees) is possible with the use of an extended travel servo or an NG Hobbies SSV3.5 servo stretcher (option below). Rather than supporting the weight of the camera on the weak servo connection, the pan is mounted to a super-durable metal mechanism rotating on precision bearings.
The modules are supplied with options for various servos servos depending on your budget or requirements.
The module can be attached to the plane of your choice with four screws.
Dimensions listed below in the pictures.
The included camera mounts includes extended screws for a solid mount of all the "full size" Ready Made RC, LLC cameras, including the RMRC-420, RMRC-480, RMRC-540, RMRC-600XV, RMRC-700XV. It includes a pop out rear panel for the cameras with built in on screen controls.
Smaller cameras may be mounted using double sided adhesive foam tape (not included). Some cameras not listed above may require modifications to the camera mount. We hope to add additional camera brackets soo!
Precision l
aser cut fi
ber reinforced
components and required gears, bearings, and other hardware for pan/tilt module.
Two 9g Servos (default option)
Zip
-ties to hold for holding your wiring in place.
Medium CA
5 minute epoxy
Check price and availability
Found 11 years, 9 months ago