ngHobbies
RED ALU RIGGER FOR MK HEXA XL
,
This is the Red aluminum rigger only, for the Mikrokopter ...ngHobbies
EPI OSD PCB ONLY FOR MIKROKOPTER
The following items are included in this kit:, , Doumentation in english:, Click here,
The EPI OSD is an open source project just like ...ngHobbies
RECOM 5V/1.5A SWITCHING VOLTAGE REGULATOR
| Wide input voltage range | 4.75~18V |
| Dimensions | 11.5 x 8.5 x 17.5mm |
| Weight | 2gr. |
Features:, Efficiency up to 94%, non isolated, no heatsink needed, Datasheet:, Click here,
INNOLINE converters are RECOM's line of innovative high efficiency stepdown ...ngHobbies
NAVI CTRL 1.1 PCB BOARD
For building instructions and part lis click the line below:, Mikrokopter wiki,
This is the bare PCB for the Navi Ctrl 1.1 ...ngHobbies
4 CELL BALANCING ADAPTER
Package contains:, One balancing cable for 4 cell batteries.,
This is a balancer adapter for the 4 cell Vislero ...ngHobbies
MOTOR ANGLE ADAPTER
Package contains:, - 2 adapters and necessary mounting screws., Documentation:, Click here,
These adapters are used to tilt the motors by a ...ngHobbies
LED PARTS PACKAGE
The package contains:, 3 x BC807 500mA SOT-23 Transistors, Documentation:, Click here,
This package contains all the neccessary parts to install on ...ngHobbies
MINI 4 SPEED CONTROLLER DISTRIBUTION BOARD
Specifications:, , Documentation:, -,
This is mini 4 power distribution set. • 1 x ...ngHobbies
HEXA POWER DISTRIBUTION BOARD
| • Dimensions | 120 x 120 x 1 mm |
Specifications:, , Documentation:, -,
This is an 6-fold power distribution printed circuit board. Using ...ngHobbies
FLEXIBLE GREEN LED STRIP
| - Length | 10cm (6 x LED) |
| - Voltage required | 12V |
| - Mounting | remove the protective layer from the bottom to stick it to your MK. |
Technical Data:, Package contains:, One strip of 10cm long felxible green LED strip with 6 LED's on it.,
This is a felxible high output green LED strip. Usually ...