SDSHobby
APM2.5 / APM2.52 /APM2.6 Power Module/ Current Module (APM Power Module) with 5.3VDC BEC
| Max input voltage | 50V |
| Max current sensing | 90A |
| 5. Function | used to detect |
Specifications:, Product Description:, 1. The APM Power Module is a simple way of providing your APM with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through, Note:, The Power Module is only designed to power APM, a RC receiver and APM accessories (GPS, 3DR radio).,
Voltage and current measurement configured for 5V ADC
Switching regulator outputs 5.3V and 2.25A max
6-pos DF13 cable plugs directly to APM's 'PM' connector
a 6-pos cable.
. The on-board switching regulator
outputs 5.3V
and
a maximum of 2.25A
from up to a 4S LiPo battery. The Power Module comes completely assembled with Deans connectors, and wrapped in shrink tubing for protection.
3.
Maximum input voltage 50V, mensurability maximum current is 90A
; achieve co
ntrol board for battery electric quantity and voltage monitoring.
4. Voltage current detection design parameters are fit with 3DR official design parameter, ground-station (mission planer) the settings can directly refer to the official wiki settings
.
battery voltage and battery current
; flight control board receive this two signal, then calculate battery remaining capacity and estimate flying time.
6. Compared with no welding wire current modules on the market, our current welding the wires plug module before they leave the factory, and factory calibration, test results more accurate,and the module on the sets with heat shrink tubing, effectively prevent the short-circuited happen.
It is not designed to power servos. Use your aircraft's own ESC/BEC for that.
Check price and availability
Found 10 years, 9 months ago