SDSHobby
APM2.5 / APM2.52 /APM2.6 Power Module/ Current Module (APM Power Module) without the BEC
| Max input voltage | 50V |
| Max current sensing | 90A |
Product Description:, Function : used to detect battery voltage and battery current; flight control board receive this two signal, then calculate battery remaining capacity and estimate flying time., Note:, The Power Module is only designed to power APM, a RC receiver and APM accessories (GPS, 3DR radio).,
Voltage and current measurement configured for 5V ADC
6-pos DF13 cable plugs directly to APM 2.5's 'PM' connector
All cables and plugs are welding, it is ready to use.
Maximum input voltage 50V, mensurability maximum current is 90A; achieve control board for battery electric quantity and voltage monitoring.
Voltage current detection design parameters are fit with 3DR official design parameter, ground-station (mission planer) the settings can directly refer to the official wiki settings.
The APM Power Module is a simple way of providing your APM with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable.
It is not designed to power servos. Use your aircraft's own ESC/BEC for that
.
Check price and availability
Found 10 years, 9 months ago