HiModel
CORONA 8-CHANNEL 2.4G TWO-WAY RF MODULE & RX SYSTEM FOR FUTABA TRANSMITTER CT8FD/CR8FD
| Transmitter modules | CT8FD |
| Hitec | Optic 6, Eclipse 7, Prism 7 |
| WFLY | WFT09, WFT08 |
| Receiver module | CR8FD, 8 channel |
| Operation Voltage Range | 6~13V |
| Operation Voltage Range | 4.8~6V |
| Sensitivity | -100dBm |
| Resolution | 10bit |
, , , , , , Specifications:, , , , , , , , , , , Compatible with following transmitters:, Futaba 3PK, 3PM, 7U, 8U, 8J, 9C, 9Z, 10C, FN SERIES, T10C, FC-18, FC-28, FF7, Compatible with any Corona two-way transmitter module, Electrical Specifications:, Transmitter module:, Operating Current: , RF output power:, Receiver module:, Operating Current: , , ,
Features: THIS IS THE AFHSS 2.4G TWO-WAY COMMUNICATION SYSTEM FROM ...HiModel
SUPER-LINK 2.4 GHZ 7-CH RECEIVER SLINK7R
| Dimension | 34.2×18.4×8.7mm |
| Control range | 800m |
| Operating Voltage | 4.8V～6.0V |
, , , , , , Specifications:, , , , , , , , , , , SUPER-LINK 2.4 GHz 7-CH Receiver SLink7R, Weight: 9g, , ,
Features: Features ●Long Range, light weight ●Easy to bind and ...2 Reviews
HiModel
ASSAN 2.4G MINI SUPER LIGHT (3.1G) 4-CHANNEL RECEIVER W/SHORT ANTENNA X8R4H
| Size | 40 x 16 x 5.5mm |
| Weight | 3.1g / 0.11 oz |
, , , , , , Specifications:, , , , , , , , , , , X8R4H is a mini 4 channels receiver., Compatible with all ASSAN's RF modules., , ,
Includes/Requires: Includes:1 x receiver 2.4G2 Reviews
HiModel
FRSKY UPGRADE CABLE FOR SENSOR HUB & DFT/DJT/DHT/8CH TELEMETRY RECEIVERS FUC-3
, , , , , , Specifications:, , , , , , , , , , , FrSky Upgrade Cable for Sensor Hub & DFT/DJT/DHT/8ch telemetry receivers FUC-3, , ,
Includes/Requires: Includes: 1 x USB PC cable set FUC-3HiModel
BATTERY VOLTAGE SENSOR FOR FRSKY TWO-WAY TELEMETRY SYSTEM
, , , , , , Specifications:, , , , , , , , , , , Battery Voltage Sensor for FrSky Two-way Telemetry System, , ,
Includes/Requires: Includes: 1 x Battery Voltage SensorHiModel
FRSKY FUEL SENSOR FGS-01
| Measurement Levels | Empty, 1/4, 2/4, 3/4, Full |
| Length of the Sensor Film | 62mm |
, , , , , , Specifications:, , , , , , , , , , , Installation: Use double-sided tape to attach both circuit board and sensor film firmly to the outside of the fuel tank., How to replace the sensor film:, Lift the locking tab on both sides of the port, insert the sensor film and press the locking tab back into place to secure the sensor film in the circuit board. Confirm the orientation is correct., Note:, The fuel tank MUST be empty at the start of this process for the sensor to accurately read the fuel level., , ,
Features: Different sensors facilitate to monitor different data, such as ...HiModel
FRSKY VARIOMETER SENSOR FVAS-01
| Measurement Range of Altitude | 0~9000m |
| Installation | Use double-sided tape to install the variometer sensor on any appropriate surface of the airframe. |
| Note | Wind will affect the altitude reading. |
, , , , , , Specifications:, , , , , , , , , , , Accuracy: 1m, , ,
Features: Different sensors facilitate to monitor different data, such as ...HiModel
FRSKY 40A AMPERE SENSOR FAS-40
| Model | FAS-140 |
| Dimension | 31.5x24.5x5mm |
| Weight | 9.7g |
| Measurement range | 0~40A |
| Maximum safe current | 40A |
| Sensor current consumption | 20mA |
| Update Rate | ≥1Hz |
, , , , , , Specifications:, , , , , , , , , , , , ,
Features: FAS-40 can be connected to FrSky Sensor Hub or ...HiModel
FRSKY TWO-WAY 2.4G MODULE W/LCD DISPLAY DHT-U
| Operating Voltage Range | 6.0V-13.0V |
| Operating Current | 50mA |
| Output Power | 60mW |
| Resolution | 3072 (>11bit) |
| V8 _Mode | Non-telemetry receivers (V8FR-HV, V8R7-HV, V8R7-SP, V8R4) |
| D_Mode | Telemetry receivers (D8R, D8RSP, D6FR, D4FR) |
, , , , , , Specifications:, , , , , , , , , , , Specification, Compatibility:, , ,
Features: Features 1) All-in-one combination of telemetry module,in-built display and ...HiModel
ZEROUAV 900MHZ DATA LINK MODULE/DATA RADIO
| Power supply | 3-6S Lipo |
| Power connector type | XT60 |
| Working frequency | 900mHz |
| Range | 2-3KM (air to ground, for reference only) |
| Antenna type | 900mhz, 5db |
| Working current | 16mA @ 25V, 6S Lipo |
| Working speed | 115200 bit |
| Signal connector | standard SMA |
, , , , , , Specifications:, , , , , , , , , , , ZeroUAV 900Mhz Data Link Module/Data Radio, , ,
Features: Data radio for YS-X6 and YS-X4. Includes/Requires: Includes: 2 ...HiModel
250MM LONG 2.4G RECEIVER ANTENNA FOR FRSKY SERIES RECEIVERS(2PCS)
| Length | 40cm |
, , , , , , Specifications:, , , , , , , , , , , 2.4G Receiver Antenna for Frsky Series Receivers, Also suit for other 2.4G receivers using same length antennas., , ,
Includes/Requires: Includes:2 x antennasHiModel
ASSAN 2.4G HITEC COMPATIBLE RF MODULE X8H V2
Features:, , Includes/Requires:, , Includes:, 1 x RF module, Hitec compatible X8-H,
THIS IS THE ASSAN 2.4GHZ RF MODULE FOR HITEC COMPATIBLE ...HiModel
FRSKY 250MM COAX ASSEMBLY FOR DIY MODULES
| Length | 250mm |
, , , , , , Specifications:, , , , , , , , , , , FrSky 250mm Coax assembly for DIY Modules, , ,
Includes/Requires: Includes:1 x coax assemblyHiModel
DHT-U TRAINER CONNECTION FOR FUTABA MTC-F
, , , , , , Specifications:, , , , , , , , , , , MTC-F, DHT-U Trainer Connection Cable for Futaba, , ,
Features: This is the simplified version of FLVS-01. Includes/Requires: Includes: ...HiModel
2.4G CORONA DSSS 3-CHANNEL RF MODULE & RX SYSTEM FOR FUTABA TRANSMITTER CT3F
| Futaba | 3PM, 3PK, 7U, 8U, 8J, 9C, 9Z and FN series. |
| Hitec | Optic 6, Eclipse 7. |
| WFLY | WFT09, WFT08. |
| Robbe | C18, C28 |
| Optional receiver | CR2D, CR3D, CR4D, CR6D, CR8D |
Features:, , CT3F is compatible with radio including:, Includes/Requires:, , Includes:, 1 x Futaba compatible RF module 2.4G CT3F,
1 x antenna 1 x 2.4G receiver CR3D