HiModel
FY21AP FPV INERTIAL ATTITUDE STABILIZER(TRADE EDITION) FY-21AP
| Incorporating the AP117 OSD module transmits these parameters | *altitude |
| Additional data can be interfaced to your PC via the Data Radio Link Module upgrade | *longitude |
| Any other configuration, please e-mail us for enquiry | feiyudz@hotmail.com |
| Includes | FY21AP (2.0) Module |
Features:, , In addition, barometric pressure data allows precise altitude hold capability. Beyond providing stabilization for the RC Pilot, under any flight conditions, connections to our other modules allow enhancements such as:, *auto-return to launch site, The FY-21AP can be installed in the following aircrafts:, Normal / Traditional fixed-wing planes, Remote Control system requirement:, The FY-21AP has been tested to work with the following RC systems:, Robbe-Futaba PPM / PCM 1024 / PCM G3 mode, 2.4 GHz systems；, Includes/Requires:, , Resources:, Download Software and instruction manual.,
1. Briefly introduce The FY21AP is a stand-alone autopilot system ...HiModel
FY31AP PATH NAVIGATION & HORNET OSD COMBO
| Inputvoltage | 4.0 ~ 6.0 Volt; |
| Currentdraw | 50mA (5V); |
| Size | 47x 27x 20 mm; |
| Weight (excluding wires) | 25g; |
| Temperature range | -25 ° C ~ +70 ° C; |
| Maximum rate of rotation | ≤ 2000 ° /s |
| Input voltage | 3.0 ~ 3.3 Volt; |
| Currentdraw | 60mA (3.3V); |
| Size | 32 x32x 10 mm; |
| Weight (excluding wires) | 22g; |
| Temperature range | -25 ° C ~ +70 ° C; |
| Includes | 1 x FY-31AP |
Features:, , By using your remote control, the FY-31AP can be turned on or off for the following functions:, • Level flight - When stabilization is activated, the FY31AP will automatically control the aircraft for smooth easy flying. For beginners in RC aircraft flying, this is advantages as it makes flight easier and increases the student pilot self-confidence. The system can be activated throughout the entire flight duration, from take off to landing., The FY-31AP provides an optional upgrade combining with the FY-OSD and the Data Radio. With this add-on, you will receive:, • First Person View (FPV) - by connecting this interface to the FY-OSD, telemetric data such as GPS, flight navigation, AHI can be displayed on your downlink video.On the other hand, it will be easier to operate FPV with the functions of automaticbalanceand automated return to home., • FY-31AP module:, • GPS module:, The FY-31AP can be installed in the following aircraft :, 1. Normal / Traditional fixed-wing planes;, The FY-31AP has been tested to work with the following RC systems:, • Robbe-Futaba PPM / PCM 1024 / PCM G3 mode, 2.4 GHz systems；, Includes/Requires:, ,
1. Attitude Flight Stabilization System (AFSS) FY31-AP is an inertial ...1 Reviews
HiModel
GWS PG-03 PIEZO GYRO
| Size | 26*27*11.3mm |
| Weight | 7.0g（0.28oz） |
| Power Supply | 4.8V-6V |
| Current Draw | 10ma（4.8V） |
| Gain Adjustment | Single rate, non-remote |
| Operating Temperature | －5�～60�C |
| Applicable R/C System | FUTABA, JR, SANWA/Airtronics, HI-TEC, Multiplex, GWS etc. |
, , , , , , Specifications:, , , , , , , , , , , , ,
Features: The PG-03 has been designed using a new micro ...HiModel
GL500 CARBON-FIBER & METAL 3D CCPM ELECTRIC HELICOPTER KIT
| ●Length | 1114mm |
| ●Height | 228mm |
| ●Main Rotor diameter | 980mm |
| ●Main Rotor length | 430mm |
| ●Flight weight | 1800g |
| Transmitter | 6-channel or above, support CCPM control mode. |
| Gyro | head lock gyro recommended. |
| Speed controller | 80A, 7.4V - 22.2V |
| Motor | 1100KV 3648 size |
, , , , , , Specifications:, , , , , , , , , , , ●Main shaft motor gear ratio: 56:11, Recommended equipment:, Servo: Futaba S3150, S9650, Hitec HS-85MG, or other 17g or 20g digital servos with similar capability and same dimensions for installation., , ,
Features: 500 Class 3D CCPM Electric Helicopter Kit. ● 80% ...1 Reviews
HiModel
FPV 2.4G/5.8G WIRELESS ALL-IN-ONE HEAD TRACING GOGGLE/VIDEO GLASSES
, , , , , , Specifications:, , , , , , , , , , , Compatible transmitters (the transmitter for RC model, not the video transmitter):, FUTABA FF-7, FF-8, FF-9, T9Z, T12MZ and T14MZ., * Other types transmitter may not supported., * there are two different colors, black and silver, we will send in random based on stock availability., , ,
Features: We stuff everything for FPV into this tiny goggle ...3 Reviews
HiModel
3 IN 1 MULTIFUNCTION LCD PROGRAM BOX (INTEGRATED WITH USB ADAPTOR AND LIPO VOLTMETER)
| 1 Size | 90mm (L) * 51mm (W) * 17mm (H) |
| 2 Weight | 65g |
| 3 Input Voltage | 4.5-12.6V |
| 4 Displayer | 16*2 characters LCD. |
| 5 Interface | Mini USB interface, ESC interface (Futaba plug), Power supply interface (Futaba plug) |
, , , , , , Specifications:, , , , , , , , , , , Specifications, (If the ESC hasn’t a built-in BEC, you must use an additional battery pack to supply the program box), , ,
Features: 1 Working Modes 1.1 Works as an individual device ...HiModel
35MHZ BA-R3P6 H/T V3 FM 6-CHANNEL MICRO RECEIVER W/O XTAL
| 4. Weight | 0.19 oz or 5.3g |
| 14. Packing | Shrink wrap |
| 15. Pin direction | horizontal pin |
, , , , , , Specifications:, , , , , , , , , , , 1. Sensitivity：＜2μV, 2. Selectivity：－53dB ±3KHz, 3. Dimensions： 35mmX15mmX10mm(1.38in x 0.59in x 0.39in), 5. Channel：1—6CH, 6. Modulation：FM PPM, 7. Compatibility：PPM transmitter (automatically compatible with positive and negative shift transmitters like Futaba, JR, Hitec, Multiplex, Sanwa, GWS etc.), 8. Effective Receiving ranging：＞300M (＞1000 feet), Note: This is the basic spec of R3PX V3 series receivers; field test could exceed this data due to different radio used. If the field test can not meet this data, please check your radio and crystals., 9. Interference test：Connect the receiver to servo (radio and receiver should be on the same channel). Turn on another radio on an adjacent channel and put it close to the receiver. The receiver should work properly (servo does not glitch at all)., 10. Crystal：UM-5 or UM-1 RX single conversion crystal, 11. Operating current：10mA, 12. Input current：5 V (4-cell) ESC is recommended to power these receivers., 13. frequency： 35M, , ,
Features: ★ BLUEARROW R3Px V3 series micro receivers are upgraded ...HiModel
WFLY 35MHZ 6 CHANNELS FM MINI RECEIVER
| Size | 35mm x 21.5mm x 15mm |
| Weight | 10g / 0.4oz ( with antenna ) |
| Band | 35Mhz |
, , , , , , Specifications:, , , , , , , , , , , WFLY 35MHz 6 Channels FM Mini Receiver, Crystal type:, UM-5, ( mini size, not included ), Compatible with Futaba compatible FM single conversion transmitters., , ,
Includes/Requires: Requires:1 x UM-5 Rx crysatalHiModel
HV SERVO DIRECT POWER SUPPLY CONNECTOR W/BEC FE-DPC-1
| Input | 6~8.4v |
| BEC output current | 2A to receiver |
| Connector type | JR/Futaba compatible |
| Wire length | 30mm |
| Weight | 13g / 0.46oz |
, , , , , , Specifications:, , , , , , , , , , , BEC output voltage: 5V, This version has one servo output, and one receiver output., * The receiver output must connect to the matching channel of the servo, for example, if the servo is for elevator, then the receiver connector should be plugged to the RX elevator channel., , ,
Features: Typical application: Use one 2S lipo to power a ...HiModel
4-WAY HV SERVO DIRECT POWER SUPPLY CONNECTOR W/BEC FE-DPC-4
| Input | 6~8.4v |
| BEC output current | 2A to receiver |
| Connector type | JR/Futaba compatible (4 connectors for servos, 4 connectors to receiver) |
| Wire length | 30mm |
| Weight | 32g / 1.13oz |
, , , , , , Specifications:, , , , , , , , , , , BEC output voltage: 5V, This version has 4 servo outputs., Wiring hint: simply plug the 4 servos to the servo outputs, and connect the matching RX connectors to the relative channels., , ,
Features: Typical application: Use one 2S lipo to power a ...HiModel
ASSAN 760US SERVO ADAPTER
| • Input pulse | ： 1520us |
, , , , , , Specifications:, , , , , , , , , , , • Input frame rate ： any type, • Output pulse ： 760us, • Out frame rate ： 333Hz, • Size ： 20 X 20 X 9.5mm, • Weight ： 4g, Popular 760us servos:, • Futaba BLS251, • Futaba S9251, • Futaba S9256, • LogicTech 6100G, • MKS DS8910, , ,
Features: ASSAN 760us servo adapter can convert the conventional 1520us ...HiModel
XQ-POWER 56G/16KG/ .12SEC 6-7.2V METAL GEAR DIGITAL SERVO XQ-S3015D
| Speed | 0.16 sec/60° @ 6V; 0.12 sec/60° @ 7.2V |
| Torque | 15kg-cm @ 6V; 16kg-cm @ 7.2V |
| Weight | 56g / 1.46oz |
| Power Supply | 6V/ 7.2V |
| Connector type | JR/Futaba compatible |
, , , , , , Specifications:, , , , , , , , , , , Dimension (mm): A: 40.8, B: 20.1, C: 38, D: 48.5, E: 10, , ,
Includes/Requires: Includes:1 x servo 1 x servo horn setHiModel
XQ-POWER 25G/2.9KG/ .09SEC DIGITAL SERVO XQ-S1016D
| Speed | 0.13 sec/60° @ 4.8V; 0.11 sec/60° @ 6V |
| Torque | 2.5kg-cm @ 4.8V; 2.9kg-cm @ 6V |
| Weight | 16g / 0.42oz |
| Power Supply | 4.8V/ 6V |
| Connector type | JR/Futaba compatible |
, , , , , , Specifications:, , , , , , , , , , , Dimension (mm): A: 22.8, B: 12.6, C: 24.8, D: -, E: -, , ,
Includes/Requires: Includes:1 x servo 1 x servo horn setHiModel
FITEC 56G/ 12.5KG/ .12 SEC TITANIUM GEAR DIGITAL SERVO FS5513M
| Dimension | 40.2 x20.0 x38.6mm |
| Weight | 56g (1.46oz) |
| Speed | 0.14sec/60°（4.8V） |
| Torque | 10.5kg.cm/146.7 oz.in（4.8V） |
| Working voltage | 4.8-6V |
| Dead band width（usec） | 2usec |
| Connector type | JR/Futaba compatible |
| Wire length | 30cm |
| Application | airplane, car, boat |
, , , , , , Specifications:, , , , , , , , , , , SPECIFICATION：, .12sec/60°（6V）, 12.5kg.cm/173.6 oz.in（6V）, , ,
Features: - Titanium gear - Dual ball bearings. - Coreless ...HiModel
FITEC 56G/ 15.5KG/ .14 SEC TITANIUM GEAR DIGITAL SERVO FT5515M
| Dimension | 40.2 x20.0 x38.6mm |
| Weight | 56g (1.46oz) |
| Speed | 0.16sec/60°(4.8V) |
| Torque | 13.4kg.cm/186.4 oz.in(4.8V) |
| Working voltage | 4.8-6V |
| Dead band width（usec） | 2usec |
| Connector type | JR/Futaba compatible |
| Wire length | 30cm |
| Application | airplane, car, boat |
, , , , , , Specifications:, , , , , , , , , , , SPECIFICATION：, 0.14sec/60°(6V), 15.5kg.cm/215.3 oz.in(6V), , ,
Features: - Titanium gear - Dual ball bearings. - Coreless ...