ReadyMadeRC
VAS - 2.4 GHZ CLOVERLEAF WHIP ANTENNA RHCP - STRAIGHT
Gain | 1.25dbic |
Beam | 360 degree doughnut |
Polarization | RHCP |
Rejection | 9db |
Connector | SMA |
Radiation pattern:,
This amazing creation is built by Alex Greve (IBCrazy). The ...ReadyMadeRC
VAS - 2.4 GHZ CLOVERLEAF ANTENNA RHCP - SIDE FEED
Gain | 1.25dbic |
Beam | 360 degree doughnut |
Polarization | RHCP |
Rejection | 9db |
Radiation pattern:,
This amazing creation is built by Alex Greve (IBCrazy). The ...ReadyMadeRC
DEANS MALE TO EC3 FEMALE ADAPTER
,
Compact adapter to go from your Deans style battery connector ...ReadyMadeRC
TINY 5V REGULATOR
IMPORTANT:, This tiny regulator using a LDO chip and converts the voltage difference to "heat". Regulator chip including a thermal shutdown on 125 degree Celsius and it can handle 800mA current easily if you can cool it. We are suggesting to maximum, : 7-18V (2-4S LiPO), : 5 volt, : 500mA nominal 1A ma, : 0.65gr,
This tiny 5volt regulator perfect for your 5volt FPV cameras ...ReadyMadeRC
FILTERED BALANCE LEAD POWER SUPPLY ADAPTER
,
Filtered power supply power adapter for FatShark and ImmersionRC transmitters. ...ReadyMadeRC
HORNET OSD WITH GPS
For FY-21AP | Fixed Altitude flying mode; for FY-3ZT/FY-31AP |
GPS speed (Unit | km/h) |
Current latitude and longitude of the plane (Format | “dddmm.mmm” ) |
The angle of turning to the return point (Unit | deg) |
Total flight time (Format | “mm.ss”) |
Course angle of flight (Unit | deg) |
(Unit | mA / h) |
Climb rate (Unit | m/s) |
The telemetry data is as below:, , Relative altitude (Unit : m), Operating temperature(Unit: ℃), Distance to take-off Point (Unit : m), The battery voltage of the video transmitter (Unit: V), Power battery voltage (Unit: V), Power battery current (Unit: A), The OSD can be controlled to show different display information via one spare channel of your radio Rx. There are 5 optional display modes controlled by the different PWM signals. You can use default mode if you do not want to change the display modes.(the 5 modes separately are as following: A. All Information Displayed; B., The modes are shown as below:, , Includes:,
Brief Introduction The Hornet- OSD overlays flight telemetry information onto ...ReadyMadeRC
REPLACEMENT FOAM FOR AVIATOR EDITION GOGGLES
,
Replacement foam for the FatShark RCV922 Aviator Edition (both new ...ReadyMadeRC
30 CM (1FT) RCA/3.5MM VIDEO CABLE-FATSHARK AND IMMERSIONRC
,
This is a 30cm audio/video cable compatible with FatShark goggles ...ReadyMadeRC
1.2 METER (3.9FT) RCA/3.5MM VIDEO CABLE-FATSHARK AND IMMERSIONRC
,
This is a 1.2 meter video cable compatible with FatShark ...ReadyMadeRC
FATSHARK BATTERY CHARGER - US VERSION
,
This is a plug in charger with US prongs for ...ReadyMadeRC
FAT SHARK XT60 STYLE CHARGE/DISCHARGE ADAPTER
,
CLOSEOUT 2.1mm barrel to XT60 style adapter for FatShark batteries. ...ReadyMadeRC
FATSHARK ZIPPER CARRY CASE FOR GOGGLES
,
The case that's included with the latest version of the ...ReadyMadeRC
FAT SHARK DOMINATOR 5.8GHZ RECEIVER MODULE
These receivers are only compatible with Airwave based systems (FatShark, ImmersionRC, some others) that use the following frequencies:, 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz,
5.8GHz video receiver module for the FatShark Dominator video glasses. ...ReadyMadeRC
FAT SHARK HEAD TRACKER TO FUTABA MINI SQUARE CABLE
,
This cable will allow you to hook up your FatShark ...ReadyMadeRC
FAT SHARK HEAD TRACKER TO EZUHF DATA CABLE - 3FT
,
This cable will allow you to hook up your FatShark ...