ngHobbies
FLEXIBLE GREEN LED STRIP
| - Length | 10cm (6 x LED) |
| - Voltage required | 12V |
| - Mounting | remove the protective layer from the bottom to stick it to your MK. |
Technical Data:, Package contains:, One strip of 10cm long felxible green LED strip with 6 LED's on it.,
This is a felxible high output green LED strip. Usually ...ngHobbies
BLACK ALU RIGGER FOR MK HEXA XL
,
This is the black aluminum rigger only, for the Mikrokopter ...ngHobbies
MKGPS 10CM CABLE ONLY
,
This package contains a replacement cable for the MKGPS. Please ...ngHobbies
APC SLOW FLYER 12X3.8 PUSHER PROPELLER
| - External diameter | 12" |
| - Pitch | 3.8" |
| - Mounting hole | 5mm |
Technical Data:, Package contains:, One propeller, manual and rings.,
This is a 12 x 3.8 slow flyer propeller that ...ngHobbies
QUADROPPM KIT 12 CHANNEL
Please note:, , Documentation:, Click here,
The Mikrokopter flight controller uses a special PPM signal which ...ngHobbies
FPV TRAY FOR THE GOPRO CAMERA MOUNT
The package contains:, 1 x FPV Tray, Cables:, Do not forget to pick up a GoPro FPV cable from here:, GoPro Camera Cables,
This is an FPV tray expansion for the GoPro camera ...ngHobbies
MIKROKOPTER QUADRO XL
| http | //www.nghobbies.com/cart/index.php?main_page=page&id=23 |
| Note | There is NO battery included with this kit. |
| http | //www.mikrokopter.de/ucwiki/en/MK-Quadro |
| http | //www.mikrokopter.com/ucwiki/en/Mikrokopter-Get-started |
| http | //www.mikrokopter.com/ucwiki/en/FlightCtrlManual |
| http | //www.mikrokopter.com/ucwiki/en/BrushlessCtrl |
| http | //www.mikrokopter.com/ucwiki/en/SerCon |
| http | //www.mikrokopter.com/ucwiki/en/ElectronicConnections |
| http | //www.mikrokopter.com/ucwiki/en/MikroKopter-Tool |
| http | //www.mikrokopter.de |
| http | //forum.mikrokopter.de/forum-17.html |
NOTE:, Please note this kit is, Please make sure you read and understand the warranty information on these kits before purchasing:, The Mikrokopter is an open source project with a very big support from Germany and all over Europe. The Mikrokopter kit contains everything to get the Mikrokopter in the air in about 5-10 hours of work. The skills needed to make this happen are: soldering, mechanical, good understanding of electronics, airplanes. To fly the Mikrokopter you need a good understanding of helicopter controls. If you ever flew a model helicopter you'll be flying the Mikrokopter in no time., The package contains:, , Documentation:, Assembly manual:, English getting started page:, English Flight controller manual:, English Brushless ESC manual:, English Serial converter manual:, English wiring diagram:, English Mikrokopter tool:, There is also an international section of the Mikrokopter forum:,
pre-order only . We will order this when you place ...