HobbyWireless
FY-91Q NAVIGATION EDITION
| System Specifications | FY-91Q Module |
| Mode 3 | Return to Home |
| Mode 1 | Stabilizer Mode |
| Mode 1 | Stabilized Mode |
| Mode 2 | Automated Hover Hold. |
| Mode 3 | Automated Return to Home Mode. |
Details:, FY-91Q flight controller for helicopters, What's Included:, , FY-91Q Navigation Edition contains the following hardware:, • FY-91Q control module x 1;, :, The FY91Q can be installed and flown it the following multi-rotor aircraft:, , :, FY-91Q have been tested to work with the following RC systems:, • Robbe-Futaba PPM / PCM 1024 / PCM G3 mode, 2.4 GHz systems, Mode 2:, Automated Hover Hold,
Multi-rotor flight stabilization & Autopilot System • FY91Q RC receiver ...HobbyWireless
TSLRS TX700 UHF TRANSMITTER
Details:, The Tx700 features all the good know functions from previous versions, but with the new hardware and software, it support Fixed/Variable PPM input, Futaba input, all up to 12Channels, it has Head tracker input, AUX input (for option boards), Option board port, output power switch, Firmware update port, Status Led, Military standard input plugs with screw protection, and a new design that reduces the height dramatically. Tx700 also supports sequential fail safe, can be upgraded(with option board) to a wireless modem(bidirectional), with serial control thru USB. Remember to buy the TSLRS USB upgrader. Kit also includes a deluxe gift-box for high level of protection, 1 antennas, 2 TSLRS vinyl stickers to let your buddies know what equipment you are flying with. 1 TSLRS Keyhanger, and a calibration chart that verifyes the human touch, and the calibrated output and testing of the hardware.,
HobbyWireless
W-TRACKER WIRELESS HEAD TRACKER SYSTEM
Details:, , The package includes:,
This is the newest concept in head tracking system for ...HobbyWireless
TX-V524 500MW 2.4 GHZ PLUG AND PLAY TRANSMITTER WITH WIRES - LAWMATE
| Nominal output impedance | 50 ohms |
| 75-ohm impedance | 1Vp-p |
| 10k ohm impedance | 1Vp-p |
| Sub carrier frequency | 6.5MHz |
| Operation temperature | -10 to 40 degrees Celsius |
| Storage temperature | -40 to 80 degrees Celsius |
| Operating humidity | 20 to 80% |
| Dimensions | 27mm x 23mm x 13mm (including attached heat sink) |
| Weight | 18g (transmitter only) |
Details:, , The plug and play board has lots of important features built-in such as:, - High quality microphone, Features:, , Specifications:, , Operating Voltage: 5.5 - 13 volts DC (to use with 12V camera you can only power the transmitter using 12V source, 3S 11.1V Lipo battery works great)., Note:, All transmitters shipped to any addresses within US territory will have only the Channel 1 (2410 MHz) available., Disclaimer:, Hobby Wireless is not responsable any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility.,
This is a plug and play transmitter only, part of ...HobbyWireless
TX-V1024 1000MW 2.4 GHZ PLUG AND PLAY TRANSMITTER WITH WIRES - LAWMATE
| Nominal output impedance | 50 ohms |
| Operating Voltage | 10.5 - 13 volts DC |
| 75-ohm impedance | 1Vp-p |
| 10k ohm impedance | 1Vp-p |
| Sub carrier frequency | 6.5MHz |
| Operation temperature | -10 to 40 degrees Celsius |
| Storage temperature | -40 to 80 degrees Celsius |
| Operating humidity | 20 to 80% |
| Weight | 40g (transmitter only) |
Details:, This is a plug and play transmitter only, part of our FPV1024 plug and play system., The plug and play board has lots of important features built-in such as:, - High quality microphone, Features:, , Specifications:, , Notes:, All transmitters shipped to any addresses within US territory will have only the Channel 1 (2410 MHz) available., Disclaimer:, Hobby Wireless is not responsable any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility.,
This combo uses PLL (Phase-Locked Loop) technology to prevent frequency ...HobbyWireless
EZUHF RX LITE RECEIVER 8 CH
| Power Requirements | ► 9-12v DC 85m. |
Details:, The EzUHF R/C control system is a reliable R/C control up link for FPV and UAV pilots who desire a robust control system for safe control at longer distances., Features/ Specifications:, ► Reliable FHSS Link, Dimensions:, ► 85 x 74 x 23mm 118g., Note:, How to make your own antenna for this receiver.,
It was designed with the FPV/ UAV pilot in mind, ...HobbyWireless
EZUHF LONG RANGE RADIO CONTROL TRANSMITTER
Details:, If you're looking to to extend the range of your RC radio transmitter to further with your RC model, then we the EZUHF is one of the best options available in the market., Features:, , Features:, ► Height 69.8 mm.,
It's an fantastic piece of engineering, it's a must-have for ...HobbyWireless
CRANE II FULLY ASSEMBLED CAMERA GIMBAL SET WITH SERVOS
| Features | ► 6061 CNC Metal. |
| ► Size | 125 x 115 x65. |
| ► Weight | 97g. |
| ► Side tilt | ± 22.5 degrees. |
| ► Vertical tilt | ± 120 degrees. |
| Delivery content | ► CRANE |
Details:,
► 100% Full Carbon Fiber Frame. ► Special engineered design ...HobbyWireless
TOWER PRO SG-50 MICRO SERVO
| *Operating Voltage | 3.0V - 7.2V |
| *Operating Speed | 0.08sec/60 degrees at no load |
| *Stall Torque | 0.8kg/cm |
| *Motor Type | coreless motor |
| *Gear Type | All Nylon Gear |
| *Connector Wire Length | 150mm |
| *Dimensions | 20.9mm x 11.4mm x 22mm |
| *Weight | 5.0g |
Details:, , Item Descritpion:, , Specifications:, , Compatible with:,
Reliable and low cost micro servo the Tower Pro MG-50 ...HobbyWireless
FPV584 PLUG AND PLAY 5.8 GHZ 400MW WIRELESS SYSTEM - NEW VERSION
| - Working voltage | DC 7.2 - 12v (9 - 12v performs better) |
| - 8 Selectable channels | DIP switches |
| Frequencies | CH1 |
| - Current consumption | ~280mA |
| - Dimensions | 14 x 26 x 39 mm (0.45" x 1" x 1.5" inches). |
| - 8 Selectable channels | DIP switches |
| Frequencies | CH1 |
| - Working voltage | 8-12 VDC (runs cooler with 8V) |
| - Current consumption | 120mAh |
| - Dimensions | 13 x 52 x 60 mm (0.4" x 2" x 2.5" inches). |
Details:, Don't let the low cost for the system fool you. It can out perform many of more expensive systems sold out there., Transmitter's features:, - Output Power：400mW, Receiver's features:, - R5800 Dual (2x) Audio and Video outputs., Includes:-, Note:, No license is required to purchase it, however in order to legally operate within USA an, Disclaimer:, Hobby Wireless is not responsable any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility.,
This another great option to those whom want to do ...HobbyWireless
FPV582 PLUG AND PLAY 5.8 GHZ 200MW WIRELESS SYSTEM - NEW VERSION
| - Working voltage | DC 7.2 - 12v (9 - 12v performs better) |
| - 8 Selectable channels | DIP switches |
| Frequencies | CH1 |
| - Current consumption | 180mAh |
| - Dimensions | 14 x 26 x 39 mm (0.45" x 1" x 1.5" inches). |
| Receiver's features | - Dual (2x) |
| - 8 Selectable channels | DIP switches |
| Frequencies | CH1 |
| - Working voltage | 8-12 VDC (runs cooler with 8V) |
| - Current consumption | 120mAh |
| - Dimensions | 13 x 52 x 60 mm (0.4" x 2" x 2.5" inches). |
Details:, Don't let the low cost for the system fool you. It can out perform many of more expensive systems sold out there., Transmitter's features:, - Output Power：23dBm, Includes:-, Note:, , Disclaimer:, Hobby Wireless is not responsable any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility.,
This another great option to those whom want to do ...HobbyWireless
TX-V512 500MW 1.2 GHZ PLUG AND PLAY TRANSMITTER WITH WIRES - LAWMATE
| 6 channels | CH1-1080 CH2-1120 CH3-1160 CH4-1200 CH5-1010 CH6-1040 MHz. |
| Nominal output impedance | 50 ohms |
| 75-ohm impedance | 1Vp-p |
| 10k ohm impedance | 1Vp-p |
| Sub carrier frequency | 6.5MHz |
| Operation temperature | -10 to 40 degrees Celsius |
| Storage temperature | -40 to 80 degrees Celsius |
| Operating humidity | 20 to 80% |
| Dimensions | 27mm x 23mm x 13mm (including attached heat sink) |
| Weight | 18g (transmitter only) |
Details:, (We can't ship this item to US address, because the available channels are not legal in USA)., The plug and play board has lots of important features built-in such as:, - High quality microphone, Features:, , Specifications:, , Operating Voltage: 5.5 - 13 volts DC (to use with 12V camera you can only power the transmitter using 12V source, 3S 11.1V Lipo battery works great)., Disclaimer:, Hobby Wireless is not responsable any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility.,
This is a plug and play transmitter only, part of ...HobbyWireless
TX-V905 500MW 900 MHZ PLUG AND PLAY TRANSMITTER.
| Nominal output impedance | 50 ohms |
| Operating Voltage | 10.5 - 13 volts DC |
| 75-ohm impedance | 1Vp-p |
| 10k ohm impedance | 1Vp-p |
| Sub carrier frequency | 6.5MHz |
| Operation temperature | -10 to 40 degrees Celsius |
| Storage temperature | -40 to 80 degrees Celsius |
| Operating humidity | 20 to 80% |
| Weight | 27g (transmitter only) |
Details:, This is an easy to use plug and play transmitter only, part of our FPV905 plug and play system., The plug and play board has lots of important features built-in such as:, , Channels:, CH1 910 MHz (USA), Features:, * 500mW RF output power Plug and Play., Specifications:, Note:, All transmitters shipped to any addresses within US territory will have only the Channel 1 (910 MHz) available., Disclaimer:, Hobby Wireless is not responsable any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility.,
This combo uses PLL (Phase-Locked Loop) technology to prevent frequency ...HobbyWireless
TX-V1012 1000MW 1.2GHZ PLUG AND PLAY TRANSMITTER - LAWMATE - ALSO AVAILABLE TO USA CUSTOMERS
| Nominal output impedance | 50 ohms |
| Operating Voltage | 10.5 - 13 volts DC |
| 75-ohm impedance | 1Vp-p |
| 10k ohm impedance | 1Vp-p |
| Sub carrier frequency | 6.5MHz |
| Operation temperature | -10 to 40 degrees Celsius |
| Storage temperature | -40 to 80 degrees Celsius |
| Operating humidity | 20 to 80% |
| Weight | 40g (transmitter only) |
Details:, This is a plug and play transmitter only, part of our FPV1012 plug and play system., The plug and play board has lots of important features built-in such as:, - High quality microphone, Features:, , Specifications:, , Disclaimer:, Hobby Wireless is not responsable any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility.,
This combo uses PLL (Phase-Locked Loop) technology to prevent frequency ...HobbyWireless
TOWER PRO MG-90 MINI SERVO
| * Dimension | 26mm*13mm*24mm |
| * Operating Speed | 0.12sec/60degree(4.8V) |
| * Stall Torque | 1.6kg/cm |
| *Motor Type | coreless motor |
| *Gear Type | All Nylon Gear |
| *Connector Wire Length | 150mm |
Details:, , Item Descritpion:, , Specifications:, , * Weight:9G, Compatible with:,
Reliable and low cost servo the Tower Pro MG-90 has ...