HobbyWireless
RSSI BUFFER FOR OSD PRO
| Operating Voltage | 5VDC (powered by EagleTree eLogger). |
| Current Draw | 2 milliamps. |
| RSSI Voltage Range | 0 - 4.0 VDC. |
| RSSI Input ohms | > 1 megohms (DC). |
| Input Impedance | 330K ohms (AC). |
| Size/Weight | 0.45 x 0.73 inches (11 x 19 mm), 2 grams. |
| Operating Voltage | 5.0VDC (4.5 - 5.5 VDC allowed). |
| Current Draw | 2 milliamps. |
| RSSI Range | 0 - 4.0 VDC. |
| RSSI Input ohms | > 1 megohm. |
| RSSI Impedance | Input IN1 = 330K ohms @ 1KHz. |
| Size/Weight | 0.45 x 0.73 inches (11 x 19 mm), 2 grams. |
| can be used with other OSD designs if the 3-wire cable’s pinout is observed, as follows | Black Wire |
| Red Wire | Buffered RSSI signal output (to OSD) |
| White Wire | Not Used (no connection) |
Details:, The RSSI Buffer is a tiny-sized accessory that is used to connect a R/C receiver's analog RSSI (relative signal strength indication) signal to the EagleTree eLogger V3 / OSD Pro system. It uses the TEMP1 input on the eLogger V3 telemetry module., Specification and Features:, Installation Instructions:, Click Me!, Installation Video:, Click Me!, Cable Pin-Out Information:, , Note:, Common circuit ground is provided by the IN1 or IN2 signal ground connection. Please,
This RSSI buffer is recommended for all EagleTree OSD-Pro installations ...HobbyWireless
HORNET OSD + FY-31AP FLIGHT STABILIZER SYSTEM, GPS AUTO-PILOT FUNCTIONS
| Inputvoltage | 4.0 ~ 6.0 Volt; |
| Currentdraw | 50mA (5V); |
| Size | 47x 27x 20 mm; |
| Weight (excluding wires) | 25g; |
| Temperature range | -25 ° C ~ +70 ° C; |
| Maximum rate of rotation | ≤ 2000 ° /s |
| Input voltage | 3.0 ~ 3.3 Volt; |
| Currentdraw | 60mA (3.3V); |
| Size | 32 x32x 10 mm; |
| Weight (excluding wires) | 22g; |
| Temperature range | -25 ° C ~ +70 ° C; |
| For FY-21AP | Fixed Altitude flying mode; for FY-3ZT/FY-31AP |
| GPS speed (Unit | km/h) |
| Current latitude and longitude of the plane (Format | “dddmm.mmm” ) |
| The angle of turning to the return point (Unit | deg) |
| Total flight time (Format | “mm.ss”) |
| Course angle of flight (Unit | deg) |
| (Unit | mA / h) |
| Climb rate (Unit | m/s) |
Details:, FY-31AP, By using your remote control, the FY-31AP can be turned on or off for the following functions:, , The FY-31AP provides an optional upgrade combining with the FY-OSD and the Data Radio. With this add-on, you will receive:, , • FY-31AP module:, , • GPS module:, , The FY-31AP can be installed in the following aircraft :, , Any other configuration , please e-mail us for enquiry:, service@feiyu-tech.com, The FY-31AP has been tested to work with the following RC systems:, , The telemetry data is as below:, , Relative altitude (Unit : m), Operating temperature(Unit: ℃), Distance to take-off Point (Unit : m), The battery voltage of the video transmitter (Unit: V), Power battery voltage (Unit: V), Power battery current (Unit: A), The OSD can be controlled to show different display information via one spare channel of your radio Rx. There are 5 optional display modes controlled by the different PWM signals. You can use default mode if you do not want to change the display modes.(the 5 modes separately are as following:, , The modes are shown as below:,
Attitude Flight Stabilization System (AFSS) 1. Attitude Flight Stabilization System ...HobbyWireless
FY-91Q NAVIGATION EDITION
| System Specifications | FY-91Q Module |
| Mode 3 | Return to Home |
| Mode 1 | Stabilizer Mode |
| Mode 1 | Stabilized Mode |
| Mode 2 | Automated Hover Hold. |
| Mode 3 | Automated Return to Home Mode. |
Details:, FY-91Q flight controller for helicopters, What's Included:, , FY-91Q Navigation Edition contains the following hardware:, • FY-91Q control module x 1;, :, The FY91Q can be installed and flown it the following multi-rotor aircraft:, , :, FY-91Q have been tested to work with the following RC systems:, • Robbe-Futaba PPM / PCM 1024 / PCM G3 mode, 2.4 GHz systems, Mode 2:, Automated Hover Hold,
Multi-rotor flight stabilization & Autopilot System • FY91Q RC receiver ...HobbyWireless
FY-31AP ATTITUDE FLIGHT STABILIZATION SYSTEM (AFSS)
| Inputvoltage | 4.0 ~ 6.0 Volt; |
| Currentdraw | 50mA (5V); |
| Size | 47x 27x 20 mm; |
| Weight (excluding wires) | 25g; |
| Temperature range | -25 ° C ~ +70 ° C; |
| Maximum rate of rotation | ≤ 2000 ° /s |
| Input voltage | 3.0 ~ 3.3 Volt; |
| Currentdraw | 60mA (3.3V); |
| Size | 32 x32x 10 mm; |
| Weight (excluding wires) | 22g; |
| Temperature range | -25 ° C ~ +70 ° C; |
Details:, , By using your remote control, the FY-31AP can be turned on or off for the following functions:, , The FY-31AP provides an optional upgrade combining with the FY-OSD and the Data Radio. With this add-on, you will receive:, , GPS module:, , The FY-31AP can be installed in the following aircraft :, , Any other configuration , please e-mail us for enquiry:, service@feiyu-tech.com, The FY-31AP has been tested to work with the following RC systems:,
1. Attitude Flight Stabilization System (AFSS) FY31-AP is an inertial ...HobbyWireless
TSLRS V6 PRO UHF TRANSMITTER - INCREASES THE RANGE OF RC RADIOS
| RF Power output | 0.5W or 1W or 2W. The 2W setting can now be used as long as you like. use selectable |
| Supply Voltage | 6-25V using internal switchmode converter also included inside the nice aluminium |
| Supply current | depends on input voltage, but input power is 3 times RF out power |
| Spurs | < 60dB and 80dB under carrier, improved new double low pass filter |
| Temperature range | -40C to +70C tested |
| Hitech Aurora 9, take out normal RF module and use module pins from left | 1=ppm, 2=supply, 3=GND (4 and 5 are not used) |
Details:, The New PRO version released Feb2012 is a improved version of the V5., Includes:, 1x Transmitter PRO V6 0.5-2W 433Mhz built in regulator,
New radio system, still compatible with older versions rx With ...HobbyWireless
COMPLETE OSD PRO 100A 10 HZ GPS AND AUTO-PILOT SYSTEM W/ WIRE LEADS - V4 (OPEN BOX)
| New | Artifical Horizon Display |
| Web Site | www.eagletreesystems.com/Support/support.html |
| BELLEVUE, WA 98006 Phone | 425-614-0450 |
Details:, , NOTE: A customer bought this kit and dry fit it together and decided he didn't want it afterall. Everything is here and everything works just like new. . It has not been installed and never flown., Here are some examples:, * GPS Parameters (Distance to Home, Home Arrow, GPS Altitude, Ground Speed, Course, and more), Instruction Manual:, Click Me!, See the video below for an example of the AHI display tracking the horizon:, , Package Includes:, , E-mail:, sales@eagletreesystems.com,
We’re pleased to introduce the Eagle Tree OSD Pro.The OSD ...