ReadyMadeRC
FY-901 MULTI-ROTOR FLIGHT STABILIZATION CONTROLLER
| mail us | service |
The FY-901 for multi-rotor copter can be used in the following models:, , :, , The FY-901 has been tested to work well with the following RC system:, , The FY-901Operating Mode for multi-rotor copter supports two flight modes :, , 1: Auto-Stabilization mode., : 3D Control Mode., Gyroscope initialization (re-setting):, , Out of the box, the FY-901 has been fully initialized. However, if the following condition occurs, resetting the gyro is recommended:, , NOTE:,
Introduction FY-901 has integrated three-axis gyro and three-axis accelerometer, which ...HobbyWireless
FUTABA TYPE SERVO EXTENSION 6" (150MM)
Details:,
- Male/Female universal J-type connectors fit both Futaba, Hitec and ...HobbyWireless
SEAGULL WIRELESS DASHBOARD FLIGHT SYSTEM, 900 MHZ, 200MW
| Seagull Telemetry | Find out what's going on while you fly! |
| Web Site | http |
| BELLEVUE, WA 98006 Phone | 425-614-0450 |
Details:, Seagull Wireless Dashboard Flight System, 900 MHz, 200mW (US FCC Approved, up to 1.2 Miles Range with included Wire Antennas) (SEA-FLIGHT-900), The Seagull Telemetry system has 3 main components:, , These components let your monitor your model in 3 different ways:, , Do you need even more data? Our Seagull Telemetry system is fully expandable, with a whole host of additional sensors, available below. Here are just a few examples of what you can do with additional sensors:, , E-mail:, sales@eagletreesystems.com,
You’ve got a lot invested in your RC Plane, Heli ...HobbyWireless
COMPLETE OSD PRO 150A 10HZ GPS AND AUTO-PILOT SYSTEM W/ WIRE LEADS - V4
| New | Artifical Horizon Display |
| Web Site | www.eagletreesystems.com/Support/support.html |
| BELLEVUE, WA 98006 Phone | 425-614-0450 |
Details:, , Here are some examples:, * GPS Parameters (Distance to Home, Home Arrow, GPS Altitude, Ground Speed, Course, and more), Instruction Manual:, Click Me!, See the video below for an example of the AHI display tracking the horizon:, , Package Includes:, , E-mail:, sales@eagletreesystems.com,
We’re pleased to introduce the Eagle Tree OSD Pro.The OSD ...HobbyWireless
COMPLETE OSD PRO 100A 10HZ GPS AND AUTO-PILOT SYSTEM W/ CONNECTORS - V4
| New | Artifical Horizon Display |
| Web Site | www.eagletreesystems.com/Support/support.html |
| BELLEVUE, WA 98006 Phone | 425-614-0450 |
Details:, , Here are some examples:, * GPS Parameters (Distance to Home, Home Arrow, GPS Altitude, Ground Speed, Course, and more), Instruction Manual:, Click Me!, See the video below for an example of the AHI display tracking the horizon:, , Package Includes:, , E-mail:, sales@eagletreesystems.com,
We’re pleased to introduce the Eagle Tree OSD Pro.The OSD ...HobbyWireless
COMPLETE OSD PRO 100A 10 HZ GPS AND AUTO-PILOT SYSTEM W/ WIRE LEADS - V4
| New | Artifical Horizon Display |
| Web Site | www.eagletreesystems.com/Support/support.html |
| BELLEVUE, WA 98006 Phone | 425-614-0450 |
Details:, , Here are some examples:, * GPS Parameters (Distance to Home, Home Arrow, GPS Altitude, Ground Speed, Course, and more), Instruction Manual:, Click Me!, See the video below for an example of the AHI display tracking the horizon:, , Package Includes:, , E-mail:, sales@eagletreesystems.com,
We’re pleased to introduce the Eagle Tree OSD Pro.The OSD ...HobbyWireless
M.I.G. HEAD TRACKER FOR FUTABA, DX8, FLYSKY, TH9B, IMAX 9X, TURNIGY 9X AND MORE...
| - Futaba | in general Futaba 7 series radios and above support the HT |
| Unsupported radios | - Hitec Aurora9 |
Details:, Fatshark came out with M.I.G, a new head tracking system that uses a combination of Magnetic Inertion Gyro, Known Supported radios:, - ezUHF (note ezUHF supports HT independently from the radio used, if your radio does not support HT, then can add HT via ezUHF, : The HT PCB can be easily damaged by accidentally applying voltage to the PPM line or vise versa, damage your radio. Fat Shark will not warranty any damage due to modified cables. Cables are inexpensive and in stock at most retailers.,
sensors that self-corrects any drift. No need to be pointing ...HobbyWireless
TOWER PRO SG-50 MICRO SERVO
| *Operating Voltage | 3.0V - 7.2V |
| *Operating Speed | 0.08sec/60 degrees at no load |
| *Stall Torque | 0.8kg/cm |
| *Motor Type | coreless motor |
| *Gear Type | All Nylon Gear |
| *Connector Wire Length | 150mm |
| *Dimensions | 20.9mm x 11.4mm x 22mm |
| *Weight | 5.0g |
Details:, , Item Descritpion:, , Specifications:, , Compatible with:,
Reliable and low cost micro servo the Tower Pro MG-50 ...HobbyWireless
TOWER PRO MG-90 MINI SERVO
| * Dimension | 26mm*13mm*24mm |
| * Operating Speed | 0.12sec/60degree(4.8V) |
| * Stall Torque | 1.6kg/cm |
| *Motor Type | coreless motor |
| *Gear Type | All Nylon Gear |
| *Connector Wire Length | 150mm |
Details:, , Item Descritpion:, , Specifications:, , * Weight:9G, Compatible with:,
Reliable and low cost servo the Tower Pro MG-90 has ...HobbyWireless
DRAGONLINK V2 - COMPLETE LONG RANGE SYSTEM FOR RADIO CONTROL
Details:, , Note:, No license is required to purchase it, however in order to legally operate within USA an, Disclaimer:, Hobby Wireless is not responsible any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility.,
The Dragonlink became one of the most popular long range ...HobbyWireless
RSSI BUFFER FOR OSD PRO
| Operating Voltage | 5VDC (powered by EagleTree eLogger). |
| Current Draw | 2 milliamps. |
| RSSI Voltage Range | 0 - 4.0 VDC. |
| RSSI Input ohms | > 1 megohms (DC). |
| Input Impedance | 330K ohms (AC). |
| Size/Weight | 0.45 x 0.73 inches (11 x 19 mm), 2 grams. |
| Operating Voltage | 5.0VDC (4.5 - 5.5 VDC allowed). |
| Current Draw | 2 milliamps. |
| RSSI Range | 0 - 4.0 VDC. |
| RSSI Input ohms | > 1 megohm. |
| RSSI Impedance | Input IN1 = 330K ohms @ 1KHz. |
| Size/Weight | 0.45 x 0.73 inches (11 x 19 mm), 2 grams. |
| can be used with other OSD designs if the 3-wire cable’s pinout is observed, as follows | Black Wire |
| Red Wire | Buffered RSSI signal output (to OSD) |
| White Wire | Not Used (no connection) |
Details:, The RSSI Buffer is a tiny-sized accessory that is used to connect a R/C receiver's analog RSSI (relative signal strength indication) signal to the EagleTree eLogger V3 / OSD Pro system. It uses the TEMP1 input on the eLogger V3 telemetry module., Specification and Features:, Installation Instructions:, Click Me!, Installation Video:, Click Me!, Cable Pin-Out Information:, , Note:, Common circuit ground is provided by the IN1 or IN2 signal ground connection. Please,
This RSSI buffer is recommended for all EagleTree OSD-Pro installations ...HobbyWireless
HORNET OSD + FY-31AP FLIGHT STABILIZER SYSTEM, GPS AUTO-PILOT FUNCTIONS
| Inputvoltage | 4.0 ~ 6.0 Volt; |
| Currentdraw | 50mA (5V); |
| Size | 47x 27x 20 mm; |
| Weight (excluding wires) | 25g; |
| Temperature range | -25 ° C ~ +70 ° C; |
| Maximum rate of rotation | ≤ 2000 ° /s |
| Input voltage | 3.0 ~ 3.3 Volt; |
| Currentdraw | 60mA (3.3V); |
| Size | 32 x32x 10 mm; |
| Weight (excluding wires) | 22g; |
| Temperature range | -25 ° C ~ +70 ° C; |
| For FY-21AP | Fixed Altitude flying mode; for FY-3ZT/FY-31AP |
| GPS speed (Unit | km/h) |
| Current latitude and longitude of the plane (Format | “dddmm.mmm” ) |
| The angle of turning to the return point (Unit | deg) |
| Total flight time (Format | “mm.ss”) |
| Course angle of flight (Unit | deg) |
| (Unit | mA / h) |
| Climb rate (Unit | m/s) |
Details:, FY-31AP, By using your remote control, the FY-31AP can be turned on or off for the following functions:, , The FY-31AP provides an optional upgrade combining with the FY-OSD and the Data Radio. With this add-on, you will receive:, , • FY-31AP module:, , • GPS module:, , The FY-31AP can be installed in the following aircraft :, , Any other configuration , please e-mail us for enquiry:, service@feiyu-tech.com, The FY-31AP has been tested to work with the following RC systems:, , The telemetry data is as below:, , Relative altitude (Unit : m), Operating temperature(Unit: ℃), Distance to take-off Point (Unit : m), The battery voltage of the video transmitter (Unit: V), Power battery voltage (Unit: V), Power battery current (Unit: A), The OSD can be controlled to show different display information via one spare channel of your radio Rx. There are 5 optional display modes controlled by the different PWM signals. You can use default mode if you do not want to change the display modes.(the 5 modes separately are as following:, , The modes are shown as below:,
Attitude Flight Stabilization System (AFSS) 1. Attitude Flight Stabilization System ...HobbyWireless
FY-91Q NAVIGATION EDITION
| System Specifications | FY-91Q Module |
| Mode 3 | Return to Home |
| Mode 1 | Stabilizer Mode |
| Mode 1 | Stabilized Mode |
| Mode 2 | Automated Hover Hold. |
| Mode 3 | Automated Return to Home Mode. |
Details:, FY-91Q flight controller for helicopters, What's Included:, , FY-91Q Navigation Edition contains the following hardware:, • FY-91Q control module x 1;, :, The FY91Q can be installed and flown it the following multi-rotor aircraft:, , :, FY-91Q have been tested to work with the following RC systems:, • Robbe-Futaba PPM / PCM 1024 / PCM G3 mode, 2.4 GHz systems, Mode 2:, Automated Hover Hold,
Multi-rotor flight stabilization & Autopilot System • FY91Q RC receiver ...HobbyWireless
FY-31AP ATTITUDE FLIGHT STABILIZATION SYSTEM (AFSS)
| Inputvoltage | 4.0 ~ 6.0 Volt; |
| Currentdraw | 50mA (5V); |
| Size | 47x 27x 20 mm; |
| Weight (excluding wires) | 25g; |
| Temperature range | -25 ° C ~ +70 ° C; |
| Maximum rate of rotation | ≤ 2000 ° /s |
| Input voltage | 3.0 ~ 3.3 Volt; |
| Currentdraw | 60mA (3.3V); |
| Size | 32 x32x 10 mm; |
| Weight (excluding wires) | 22g; |
| Temperature range | -25 ° C ~ +70 ° C; |
Details:, , By using your remote control, the FY-31AP can be turned on or off for the following functions:, , The FY-31AP provides an optional upgrade combining with the FY-OSD and the Data Radio. With this add-on, you will receive:, , GPS module:, , The FY-31AP can be installed in the following aircraft :, , Any other configuration , please e-mail us for enquiry:, service@feiyu-tech.com, The FY-31AP has been tested to work with the following RC systems:,
1. Attitude Flight Stabilization System (AFSS) FY31-AP is an inertial ...HobbyWireless
TSLRS V6 PRO UHF TRANSMITTER - INCREASES THE RANGE OF RC RADIOS
| RF Power output | 0.5W or 1W or 2W. The 2W setting can now be used as long as you like. use selectable |
| Supply Voltage | 6-25V using internal switchmode converter also included inside the nice aluminium |
| Supply current | depends on input voltage, but input power is 3 times RF out power |
| Spurs | < 60dB and 80dB under carrier, improved new double low pass filter |
| Temperature range | -40C to +70C tested |
| Hitech Aurora 9, take out normal RF module and use module pins from left | 1=ppm, 2=supply, 3=GND (4 and 5 are not used) |
Details:, The New PRO version released Feb2012 is a improved version of the V5., Includes:, 1x Transmitter PRO V6 0.5-2W 433Mhz built in regulator,
New radio system, still compatible with older versions rx With ...