HobbyKing
Q-BOT MICRO QUADCOPTER W/2.4GHZ RF MODULE (SPEKTRUM/JR/FUTABA COMPATIBLE)
| Width | 125mm |
| Height | 35mm |
| Weight | 26g |
| Operating Voltage | 3.7~12V DC |
| Operating Current | ≤ 100 mA |
| Operating Frequency | 2.4gHz |
| Spread Spectrum Mode | FHSS |
| Hopping Rate | 240 Jump/s |
Features:, • 2.4gHz RF module allowing for use with your own transmitter*, *Note:, Your Transmitter must have a trainer port, Quadcopter Specs:, RF Module Specs:, Battery Specification:, 3.7V Li-Po battery 120mAh, Number of Frequency Channels:20, Included in box:, Q-BOT Micro Quadcopter, Required:, Your own 4CH (5CH or more required for aerobatic mode) transmitter with trainer port (JR style 3.5mm or Futaba style 6-pin),
The Q-BOT Micro is the first micro quadcopter on the ...5 Reviews
HobbyKing
2.4GHZ A-FHSS COMPATIBLE 8CH RECEIVER (HITEC MINIMA COMPATIBLE)
| Operating Voltage Range | 3.5V~16V |
| Operating Current | 30mA |
| Operating Range | Full Range (>1.5km) |
| Dimension | 44x24x14mm |
| Weight | 9.3g |
Compatibility:, Compatible with Hitec Minima series 2.4Ghz A-FHSS transmitters, Features:, • Hitec Minima 2.4Ghz A-FHSS Compatible, Specs:, Number of Channels:8, *Note:, This unit is not designed, manufactured or supported by Hitec, nor is it a copy of a Hitec receiver.,
These receivers are a great option for users of Hitec ...5 Reviews
HobbyKing
CORONA SYNTHESIZED RECEIVER 6CH 40MHZ (V2)
| http | //www.corona-rc.com/index.php?option=com_content&task=view&id=26&Itemid=56 |
5 Reviews
HobbyKing
2.4GHZ A-FHSS COMPATIBLE 5CH MICRO RECEIVER (HITEC MINIMA COMPATIBLE)
| Operating Voltage Range | 3.0V~7.2V |
| Operating Current | 20mA |
| Operating Range | >300m |
| Dimension | 21x16x5.8mm |
Compatibility:, Compatible with Hitec Minima series 2.4Ghz A-FHSS transmitters, Features:, • Hitec Minima 2.4Ghz A-FHSS Compatible, Specs:, Number of Channels:5, Weight:2g, *Note:, This unit is not designed, manufactured or supported by Hitec, nor is it a copy of a Hitec receiver.,
These receivers are a great option for users of Hitec ...5 Reviews
HobbyKing
ZEROUAV YS-X4 AUTOPILOT GPS FLIGHT CONTROL SYSTEM FOR MULTI-ROTOR (NAVIGATOR VERSION)
| Quad-Rotor | +4, x4 |
| Hexa-Rotor | +6, x6,Y6, Rev Y6 |
| Recommended Battery | 3S~6S LiPo |
| Power Consumption | MAX 2.5W |
| Operating Temperature | -5°C to +60°C |
| Vertical | +/- 1m Horizontal |
| Suitable Wind Condition | < 8m/s (17.7mph) |
| Max Tilt Angle | 35° |
| Max Ascent/Descent Speed | <6m/s |
Features:, • Auto Take-off, Return to Home, and Landing, *Note:, For more detailed specs and information, please see the user manual available for download located under the "Files" tab below, Specs:, Multi Rotor Types supported:, Octo-Rotor:, +8, x8, V8 (Gimbal is unavailable), Supported ESC output:, 400Hz refresh frequency, Recommended Transmitter:, PCM or 2.4GHz with 6 channels at least and Failsafe function available on all channels, Ground Control Software Requirement:, Android / Windows XP SP3 / Windows 7, Flight Performance:, Hovering position accuracy (GPS mode):, Included in the box:, Complete Zero UAV YS-X4 Autopilot Flight Controller System (Navigator version),
The Zero UAV YS-X4 is a professional level multi-rotor autopilot ...5 Reviews
HobbyKing
ZEROUAV YS-X4 AUTOPILOT GPS FLIGHT CONTROL SYSTEM FOR MULTI-ROTOR (WI-FI VERSION)
| Quad-Rotor | +4, x4 |
| Hexa-Rotor | +6, x6,Y6, Rev Y6 |
| Recommended Battery | 3S~6S LiPo |
| Power Consumption | MAX 2.5W |
| Operating Temperature | -5°C to +60°C |
| Hovering position accuracy (GPS mode) | Vertical |
| +/- 1m Horizontal | +/- 2m |
| Suitable Wind Condition | < 8m/s (17.7mph) |
| Max Tilt Angle | 35° |
| Max Ascent/Descent Speed | <6m/s |
Features:, • Auto Take-off, Return to Home, and Landing, *Note:, For more detailed specs and information, please see the user manual available for download located under the "Files" tab below, Specs:, Multi Rotor Types supported:, Octo-Rotor:, +8, x8, V8 (Gimbal is unavailable), Supported ESC output:, 400Hz refresh frequency, Recommended Transmitter:, PCM or 2.4GHz with 6 channels at least and Failsafe function available on all channels, Ground Control Software Requirement:, Android / Windows XP SP3 / Windows 7, Flight Performance:, Included in the box:, Complete ZeroUAV YS-X4 Autopilot Flight Controller System (Wi-Fi version),
The Zero UAV YS-X4 is a professional level multi-rotor autopilot ...5 Reviews
BevRC
YS-X4 MULTI-ROTOR FLIGHT CONTROLLER---NAVIGATOR VERSION
| Your purchase includes | 1 WIFI module X1 |
Download the quick start guide here:, , What's added to the version:, 1 Target Lock & Fly encircle (No limitation), Product Features:, 1 Auto (Takeoff/ Go Home/Landing), Specification:, , Version differences:, The bluthtooth version has been cancelled beause of the compatible problem.,
2 Click/Touch & Fly To Point (No limitation) 3 Auto-Navigation ...BevRC
YS-X4 MULTI-ROTOR FLIGHT CONTROLLER---WIFI VERSION
Download the quick start guide here:, , Product Features:, 1 Auto (Takeoff/ Go Home/Landing), Your purchase Includes:, 1 the WIFI module X1, Specification:, , Version differences:, The bluthtooth version has been cancelled beause of the compatible problem.,
YS-X4 Autopilot system for multi-rotor is specially designed for Hobbyist. ...BevRC
FRSKY TFR8SB- COMPATIBLE WITH FUTABA FAAST RADIO WITH SBUS AND RSSI PORT
| FASST 2.4GHz Air Systems (7CH Mode/Multi Mode) | 6EX, 7C, TM-7, TM-8, T8FG, T10C, TM-10, T10CG, T12Z, T12FG, TM-14, T14MZ, etc |
| Model | TFR8SB (8CH FASST compatible receiver with RSSI & SB ports) |
| Dimension | 44.5*27.5*17mm |
| Operating Voltage Range | 3.5~10V |
| Operating Temperature Range | -10℃~80℃ |
| Mode A | RED LED blinks |
| Mode B | GREEN LED blinks |
:11.5g, :, 14ms (FS – Normal Speed Mode), Note: Be sure that when using battery or regulated output from ESC, the capacity must meet the usage conditions of servos., Use native failsafe position preset on the transmitter side:, If not disabling failsafe on the transmitter side, TFR8SB will use native failsafe position preset on the transmitter side., Set failsafe on TFR8SB side:, TFR8SB supports failsafe function for all channels. Follow the steps below to set failsafe on TFR8SB:, 1) Bind the receiver first, and disable failsafe on the transmitter side;, Note: HS mode is only applied for high-speed digital servos. Other servos should select FS mode, otherwise servos will get hot or even burn out., Note: Do not perform linking procedure while motor’s main wire is connected or engine is operating, otherwise damage may occur. After linking is completed, recycle the receiver power and check if the receiver is really under control by linked transmitter.,
It's a good choice for your multi-rotor with Naza or ...ReadyMadeRC
TSLRS TX600+ UHF TRANSMITTER
PPM signal input, with no ..." />
| Transmitter power 3 steps | 0.5W 1W and 2Watts |
| Watt / SupplyVolt = Current, the supply voltage can be anything from 6-25V. Example with a 3S lipo | 1.5W / 11V = 0.126A |
Example: 1000mAh / 126mA = 7.9 hrs, remember to keep a good safe margin, some batteryes like LIPO do not like to be fully empty., Notice: The use and operation of this product in the USA and many other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
Now able to handle any PPM signal input, with no ...ReadyMadeRC
FY-901 MULTI-ROTOR FLIGHT STABILIZATION CONTROLLER
| mail us | service |
The FY-901 for multi-rotor copter can be used in the following models:, , :, , The FY-901 has been tested to work well with the following RC system:, , The FY-901Operating Mode for multi-rotor copter supports two flight modes :, , 1: Auto-Stabilization mode., : 3D Control Mode., Gyroscope initialization (re-setting):, , Out of the box, the FY-901 has been fully initialized. However, if the following condition occurs, resetting the gyro is recommended:, , NOTE:,
Introduction FY-901 has integrated three-axis gyro and three-axis accelerometer, which ...HobbyWireless
W-TRACKER WIRELESS HEAD TRACKER SYSTEM
Details:, , The package includes:,
This is the newest concept in head tracking system for ...HobbyWireless
EZUHF RX LITE RECEIVER 8 CH
| Power Requirements | ► 9-12v DC 85m. |
Details:, The EzUHF R/C control system is a reliable R/C control up link for FPV and UAV pilots who desire a robust control system for safe control at longer distances., Features/ Specifications:, ► Reliable FHSS Link, Dimensions:, ► 85 x 74 x 23mm 118g., Note:, How to make your own antenna for this receiver.,
It was designed with the FPV/ UAV pilot in mind, ...HobbyWireless
EZUHF LONG RANGE RADIO CONTROL TRANSMITTER
Details:, If you're looking to to extend the range of your RC radio transmitter to further with your RC model, then we the EZUHF is one of the best options available in the market., Features:, , Features:, ► Height 69.8 mm.,
It's an fantastic piece of engineering, it's a must-have for ...HobbyWireless
DRAGON OSD GPS NAVIGATION SYSTEM MAIN BOARD ONLY - NO GPS ANTENNA OR CURRENT SENSOR
| Voltage | 2 ports |
| Current | 1 port |
| IMU | Artificial horizon |
Details:, The Dragon OSD+ v2 is the newest analog OSD from DragonLabs., :, , GPS:, Altitude, Ground speed, Coordinates, Satellites, Track heading, Home heading, LOS Distance, Distance to home, Barometer:, Altitude, Temperature, Variometer:, Airspeed, Vertical speed indicator, : Magnetic heading and GPS, : Elapsed time, Callsign, RSSI, Flight summary, Various display modes, Remote OSD off, Configurable border area, Configuration:, On screen menu, Configure via stick input, Configure via PC, Customizable screen layout, : Range, Altitude, Stall speed, Voltage, mAh, Audio notification, Lost signal, RSSI level, Integration:, Single servo wire link from the DragonLink for multi-channel auto-pilot, Logging:, Google Earth Logging, Autopilot:, RTH (Return to home), IMU fly-by-wire, Way points:, 20 GPS way points configurable on the PC, Hardware:, PAL/NTSC auto-detect, GPS auto-detect, UART interfaces, I2C extension bus (various devices supported), Package includes:, , Optional accessories not included:, , Software/Firmware and Manual:,
It provides a light and low cost board, but high ...