HobbyKing
TURNIGY FHSS 2.4GHZ TRANSMITTER MODULE FOR FBL100 AND Q-BOT MICRO
| Sealed Battery Specification | 3.7V Lipoly 120mAh |
| Operating Voltage | 5~12V DC |
| Operating Current | <100mA |
| Operating Frequency | 2402MHz~2477MHz |
| Spread Spectrum Mode | FHSS |
| Hopping Rate | 240 jump/s |
Features:, • Compatible with any trainer port enabled transmitter*, Specs:, Number of Frequency Channels:20, *Note:, Compatible transmitter must output PPM signal via the trainer port.,
The all new Turnigy FHSS 2.4GHz transmitter module allows you ...5 Reviews
HobbyKing
TURNIGY FBL100 3D MICRO HELICOPTER W/2.4GHZ RF MODULE (SPEKTRUM/JR/FUTABA COMPATIBLE)
| Length | 238mm |
| Height | 93.7mm |
| Weight | 50g |
| Main rotor diameter | 249mm |
| Tail rotor diameter | 45mm |
| Battery | 3.7V 300mAh 30C |
Features:, • High precision 3-axis flybarless system, *Note:, Your Transmitter must have a trainer port (JR style 3.5mm or Futaba style 6-pin) and be capable of outputting PPM signal., Specs:, Included:, 1 x Turnigy FBL100 Micro 3D Helicopter, Required:, Your own 6CH transmitter with trainer port (JR style 3.5mm or Futaba style 6-pin),
The Turnigy FBL100 is a feature packed micro 3D helicopter ...5 Reviews
HobbyKing
SUPERMICRO SYSTEMS - BRUSHLESS ESC - 3.0A
| Service Voltage | 3.7v |
| Size | 12.9x11.6x3.4mm |
| Operating Voltage | 3.3-5.0v |
Specs:, Operating Current:, 3A (maximum 5A for 5 SEC), Weight:, 0.36g without wires, 1.0g with wires and connectors, Input supported:, PPM and PWM 1KHz 2KHz 3KHz 4KHz,
The MX-3A brushless ESC is one of the nicest and ...GetFPV
3 CH RC VIDEO SWITCH
| All pin headers have same pin functions | GND, +V, Video |
Features:, , Connecting:, You can connect RC video switch to RC receiver’s regular servo channel or sum PPM connector. It will automatically detect type of RC signal., Configure PPM control channel:, To change PPM channel used to control video switch you need to toggle 8 times needed transmitter switch within 10s after video switch is powered ON., Video connectors:, SmartFPV video switch has 3 video inputs and 1 video output. Connection is made with common 3 pin servo style connectors., Video power:, All middle pins of 3 pin video connectors are interconnected to share same power between video cameras and video transmitter connected. You can power all devices either by feeding voltage to one of video devices connected or by soldering additional leads to battery input and connect battery. Battery connection leads are not included.,
Details SmartFPV 3 way RC video switch allows switching between ...GetFPV
RC CAMERA CONTROL (RCCC) V2
RCCC has following features:, , It is small 23mm x 40mm (including connectors) board weighting approximately 8g with cable that combines 3 devices: Camera shutter, Video switch and High current switch. It is controlled with sum PPM or regular servo signals from RC receiver.,
Details 3 Channel RC Video Switch (switch one of 3 ...ReadyMadeRC
3DR PIXHAWK
| Weight | 38g (1.31oz) |
| Width | 50mm (1.96") |
| Thickness | 15.5mm (.613") |
| Length | 81.5mm (3.21") |
Note:, Pixhawk is a PPM-input autopilot, which means that it gets RC input from a single cable to the receiver, either via the PPM port, the Futaba S.BUS port, or the special satellite receiver port for Spektrum gear. Most modern RC receivers (and all those sold by 3D Robotics) allow for PPM output, but some, such as non-S.BUS Futaba receivers, do not. If your receiver does not support PPM output, please add a PPM encoder board option to your order below., Pixhawk includes:, , Options:, , Microprocessor:, , Sensors:, , Interfaces:, , Power System:, , Weight and Dimensions:, ,
Pixhawk is an advanced autopilot system designed by the PX4 ...SDSHobby
PIXHAWK PIX PXI PX4 OPEN-HARDWARE AUTOPILOT FLIGHT CONTROLLER SET (AUTOPILOTS FC/ CONTROL BOARD WITH 6H GPS) FOR RC AIRPLANE/ MULTICOPTER
| . CPU | 168MHZ, 256K RAM |
Kindly Remark:, 1. The product is, :, Their positioning accuracy, speed and sensitivity are the same. The only difference is that, Weight and Sizes:, 1. Weight:, 38g (not include GPS), . Width:, 50mm, 3. Height:, 15.5mm, 4. Length:, 81.5mm, Features:, 1. Advanced, Hardware Specifications:, Processor:, 1. 32-bit 2 Mega STM32F427 Cortex M4 core with FPU, Interfaces:, 1. 5 x UART (serial ports), one high-power capable, 2x with HW flow control, Attention:, Pixhawk is a PPM-input autopilot, which means that it gets RC input from a single cable to the receiver, either via the PPM port, the Futaba S.BUS port, or the special satellite receiver port for Spektrum gear. Most modern RC receivers (and all those sold by 3D Robotics) allow for PPM output, but some, such as non-S.BUS Futaba receivers, do not.,
open-hardware and not support sales return after selling out. If ...HobbyKing
CORONA 8CH DUAL CONV. RX 35MHZ (INCL. 10 RX CRYSTAL)
| Size | 36.8*22*8.3mm |
| Weight | 8.6g(with shrink wrap) |
| Sensitivity | about 2.0ìV |
| Selectivity | ±8kHz at 65dB down |
| Number of channels | 1-8 |
| Filtering | Dual turned RF circuitry |
| Filtering | Dual 4 element ceramic filter |
| Filtering | DSP filtering in MCU with mild algorithm |
| Shift polarity | positive or negative (auto-detect) |
| Modulate | FM/PPM(pulse position modulation) |
| Case | Shrink wrap |
| Operating Voltage | 4.8V~6.0VDC |
| Operating Current | 11mA |
5 Reviews
HobbyKing
TURNIGY 9X 9CH TRANSMITTER W/ MODULE & 8CH RECEIVER (MODE 2) (V2 FIRMWARE)
| Number of Channnel | 8ch ppm/9ch pcm |
| Display | 128*64LCD |
| Support Type | Heli/Acro/Glid |
| Encoder type | ppm/pcm |
| Subtrim | Yes |
| Simulator Interface | Yes |
| Buzzer | Yes |
| Low Voltage Show | Yes |
Support user:8, Stick model:4, Required:, Battery, Included:, Turnigy 9x 9Ch Transmitter, NOTE: "SWITCH ERROR" means you have one of the switches in the wrong position when you turn the radio on. It is not a fault.,
With v2 firmware update, correcting many flaws of the previous ...5 Reviews
HobbyKing
CORONA SYNTHESIZED DUAL-CONV RECEIVER 6CH 72MHZ
| Size | 36.8*22*8.3mm |
| Weight | 8.2g(with shrink wrap) |
| Sensitivity | about 2.0ìV |
| Selectivity | ±8kHz at 65dB down |
| Number of channels | 1-6 |
| Filtering | Dual turned RF circuitry |
| Filtering | Dual 4 element ceramic filter |
| Filtering | DSP filtering in MCU with mild algorithm |
| Shift polarity | positive or negative (auto-detect) |
| Modulate | FM/PPM(pulse position modulation) |
| Case | Shrink wrap |
| Operating Voltage | 4.8V~6.0VDC |
| Operating Current | 11mA |
5 Reviews
HobbyKing
SPARTAN AP-2000I - ADVANCED CCPM MIXER, DIGITAL CYCLIC RING AND FLIGHT STABILISER
| Swashplate types | 120deg CCPM, 140deg CCPM , 90deg CCPM (4 servo). Mechanically mixed swashplates are also supported. |
| Operating voltage | 4 - 10 Volts, current draw Compact design measures |
| Weight | 25 grams |
| Operating conditions | 0 to 50 deg C, 32 to 122 deg F, 20 to 85 % humidity not condensing. |
| Storage | -20 to 70 deg C, -68 to 158 deg F, 20 to 90 % humidity not condensing. |
General features:, Works with all PCM, PPM/FM and Spread Spectrum receivers and supports both digital and conventional servos., Specifications:,
The AP-2000i is one of the most advanced aeromodelling avionics ...5 Reviews
HobbyKing
CORONA 8CH SINGLE CONV. RX 72MHZ (INCL. 10 RX CRYSTALS)
| Size | 36*22*12mm |
| Weight | 7.3g (with shrink wrap) |
| Sensitivity | about 2.0ìV |
| Selectivity | ±8kHz at 65dB down |
| Number of channels | 1-8 |
| Filtering | Dual turned RF circuitry |
| Filtering | Dual 4 element ceramic filter |
| Filtering | DSP filtering in MCU with mild algorithm |
| Shift polarity | Positive or negative (auto-detect) |
| Case | Shrink wrap |
| Operating Voltage | 4.8V~6.0VDC |
| Operating Current | 11mA |
| Modulate | FM/PPM(pulse position modulation) |
5 Reviews
HobbyKing
TURNIGY 9X 9CH TRANSMITTER W/ MODULE & 8CH RECEIVER (MODE 1) (V2 FIRMWARE)
| Number of Channnel | 8ch ppm/9ch pcm |
| Display | 128*64LCD |
| Support Type | Heli/Acro/Glid |
| Encoder type | ppm/pcm |
| Subtrim | Yes |
| Simulator Interface | Yes |
| Buzzer | Yes |
| Low Voltage Show | Yes |
Support user:8, Stick model:4, Required:, Battery, Included:, Turnigy 9x 9Ch Transmitter, NOTE: "SWITCH ERROR" means you have one of the switches in the wrong position when you turn the radio on. It is not a fault.,
With v2 firmware update, correcting many flaws of the previous ...5 Reviews
HobbyKing
GWS R6 NII 6CH FM NARO RECEIVER 40MHZ
| Weight | 7.6~8.2g |
| Ant Length | 50cm |
| System | FM (PPM) Single Conversion |
| Voltage | 3.6~7.2v |
| Current Drain | 7mA |
| Size | 20x30x9.5mm |
| Range | 300mtr+ |
| http | //www.gwsus.com/english/product/receiver/r6n.htm |
Channels: 6,
GWS R6 NII 6Ch FM Naro Receiver The R-6NII has ...5 Reviews
HobbyKing
GWS R4 PII F 4CH FM PICO RECEIVER 72MHZ
| Weight | 3.6~4.8g |
| Ant Length | 50cm |
| System | FM (PPM) Single Conversion |
| Voltage | 3.6~7.2v |
| Current Drain | 5mA |
| Size | 15x25x8.6mm |
| Range | 150mtr+ |
| http | //www.gwsus.com/english/product/receiver/r4p.htm |
Channels: 4,
GWS R4 PII F 4Ch FM Pico Receiver 72mhz For ...5 Reviews