HiModel
TOWERPRO SG-50 MICRO SERVO W/25CM LEAD
| *Dimensions | 20.9mm x 11.4mm x 22mm |
| *Operating Speed (4.8V no load) | 0.10sec/60 degrees |
| *Stall Torque | 0.8kg / 28.2 oz(4.8V); |
| *Temperature Range | -30 to +60 Degree C |
| *Dead Band Width | 7usec |
| *Lead length | 25 cm |
| Operating Voltage | 3.0-7.2 Volts |
, , , , , , Specifications:, , , , , , , , , , , *Weight: 5g, , ,
Features: TOWERPRO SG-50 Micro Servo Coreless Motor All Nylon Gear ...HiModel
POWER HD DIGITAL METAL GEAR SERVO COMBO FOR 450 CLASS HELICOPTER (3X 2215S, 1X 3688MG)
| Weight | 14.2 grams |
| Torque | 2.2KG（4.8V）2.6KG（6V） |
| Speed | 0.12″（4.8V）0.09″（6V） |
| Voltage | DC 4.8 - 6V |
| Dimension | 32.3x12x28.3mm |
| Weight | 29 grams |
| Torque | 2.5KG（4.8V）3KG（6V） |
| Speed | 0.07″（4.8V）0.06″（6V） |
| Voltage | DC 4.8 - 6V |
| Dimension | 48.4x15.1x34.4mm |
, , , , , , Specifications:, , , , , , , , , , , Specs of 2215S:, Specs of 3688MG:, , ,
Features: This is a promotion combo released recently, the combo ...HiModel
GENING 14G/ 2KG/ .07 SEC HIGH SPEED METAL GEAR DIGITAL SERVO D90MG
| Operating Voltage | 4.8-6.0 Volts |
| Operating Speed (4.8V) | 0.08sec/60° |
| Operating Speed (6.0V) | 0.07sec/60° |
| Stall Torque (4.8V) | 1.8kg.cm |
| Stall Torque (6.0V) | 2.0kg.cm |
| Dead Band Width | ≤3usec |
| Dimensions | 23.6 x 11.8 x 22mm |
| Weight | 14g |
| Bearing Type | Top Ball Bearing |
| Gear Type | Metal Gears |
| Motor Type | 3-Pole Neodynium Magnet |
| Connector Wire Length | 180mm |
| Current Drain (4.8V) | 5.3mA/idle and 140mA no load operating |
| Current Drain (6.0V) | 6.6mA/idle and 150mA no load operating |
, , , , , , Specifications:, , , , , , , , , , , Full AVCS Gyro DS mode compliant, , ,
Features: The D90MG is a high speed and accurate digital ...HiModel
12.5G/ 2.4KG/ .09 SEC DIGITAL HIGH VOLTAGE MICRO SERVO DS929HV
, , , , , , Specifications:, , , , , , , , , , , Type： DS929HV, Dimension： 22.5X11.5X24.6mm(0.88"x0.45"x0.96"), Weight： 12.5g, Working Voltage： 6．0V / 7.4V, Working Current： 200mA / 240mA, Speed： 0.10sec.60º/ 0.09sec.60º, Torque： 2.2kg.cm /2.4kg.cm, Gear Material： Metal, Wire length： 215mm, , ,
Features: THIS IS THE HIGH VOLTAGE SERIES DIGITAL SERVOS FROM ...HiModel
KST 28G/ 7KG/ .12 SEC DIGITAL SERVO FOR GLIDER WING DS125MG
| Type | DS125MG |
| Torque | 7.0kg.cm @ 6V; 6kg.cm @4.8V |
| Speed | 0.12 (sec/60°) @6V; 0.15 sec/60°@ 4.8V |
| Voltage | DC 4.5V to 6.0V |
| Dimension | 30 x 10 x 35 mm |
| Weight | 28g (with wire and connector) |
| Gear type | metal gear |
| Application | Glider wing servo |
, , , , , , Specifications:, , , , , , , , , , , , ,
Features: - Digital wing servo for glider - High precision ...1 Reviews
HiModel
40MHZ WFT 09 9-CHANNEL RADIO W/WFR08-P RECEIVER
| MODEL NO. | WFT09H |
| MODULATION | FM(PPM) and PCM |
| OUTPUT POWER | ≤700mW |
| POWER SUPPLY | 1.2V x 8 (9.6V) |
| CURRENT DRAIN | 200mA |
| Band | 40MHz |
| Receiver type | WFR08-P |
, , , , , , Specifications:, , , , , , , , , , , TRANSMITTER, RECEIVER, RECEIVER, * Both mode 1 & mode 2 are available, mode 2 will be provided by default for international orders, you can specify the stick mode by leaving a message in the Remark field on the last step when place the order., SINCE THE MANUFACTURER CHANGED THE CODING METHOD OF THEIR RADIO SYSTEM, ALL THE WFLY TRANSMITTER NOW CAN ONLY WORK WITH THEIR OWN RECEIVERS, AND ALL WFLY RECEIVERS ARE ALSO ONLY COMPATIBLE WITH THEIR OWN TRANSMITTERS., IN OTHER WORDS, THE WFLY RADIO SYSTEM NOW ARE NOT COMPATIBLE WITH OTHER FUTABA STANDARD TRANSMITTERS AND RECEIVERS!, THIS RADIO SET NOW COME IN FOAM PACKING ONLY, WITHOUT THE OUTER COLOR CARTON BOX., * Both mode 1 & mode 2 are available, mode 2 will be provided by default for international orders, you can specify the stick mode by leaving a message in the Remark field on the last step when place the order., , ,
Features: Computerized transmitter. 132 x 64 FSTN LCD, easy operating ...HiModel
XQ-POWER 30G/7.4KG/ .46SEC LOW PROFILE SERVO XQ-S3007B
| Speed | 0.5 sec/60° @ 4.8V; 0.46 sec/60° @ 6V |
| Torque | 6.8kg-cm @ 4.8V; 7.4kg-cm @ 6V |
| Weight | 30g / 0.78oz |
| Power Supply | 4.8V/ 6V |
| Connector type | JR/Futaba compatible |
, , , , , , Specifications:, , , , , , , , , , , Dimension (mm): A: 40.1, B: 23, C: 24.6, D: 51, E: 12, , ,
Includes/Requires: Includes:1 x servo 1 x servo horn setHiModel
XQ-POWER 56G/9.8KG/ .16SEC METAL GEAR WATER-PROOFING SERVO (6-7.2V) XQ-S3009M
| Speed | 0.18 sec/60° @ 6V; 0.16 sec/60° @ 7.2V |
| Torque | 8.9kg-cm @ 6V; 9.8kg-cm @ 7.2V |
| Weight | 56g / 1.46oz |
| Power Supply | 6V/ 7.2V |
| Connector type | JR/Futaba compatible |
, , , , , , Specifications:, , , , , , , , , , , Dimension (mm): A: 40.8, B: 20.1, C: 38, D: 48.5, E: 10, , ,
Features: 2S Lipo capable. Metal Gear and improved Water-proofing. * ...HiModel
KDS MODEL 2.4G 8-CHANNEL RECEIVER KDS-8XR
| Size | 52.5 x 32 x 15mm |
| Weight | 17.2g / 0.61oz |
, , , , , , Specifications:, , , , , , , , , , , KDS Model 8-channel 2.4Ghz receiver, * KDS Model receiver can only work with KDS Model RF modules., , ,
Includes/Requires: Includes: 1 x KDS-8XR 8-channel receiver1 Reviews
HiModel
FRSKY 2.4G 6-CHANNEL TWO WAY COMMUNICATION RECEIVER D6FR
| Compatible with FrSky two way telemetry modules | DFT, DJT, DHT, DHT-U |
| Dimension | 42*22*11mm |
| Weight | 7.1g |
| Operating Voltage Range | 4.0V-10.0V |
| Operating Current | 50mA |
| Specified Range | 1.5km |
| Resolution | 3072 (>11bit) |
| Frame Rate | 18ms (FS) |
| Please kindly follow the steps below to perform range check | (Note |
, , , , , , Specifications:, , , , , , , , , , , 1.1 Compatibility:, 1.2 Specification:, 9ms (HS), Setup, 2.1 Bind procedure:, 1) Turn your transmitter on and switch it to PPM mode (if not set). Turn your transmitter off., 2)Turn your transmitter on while holding the F/S button on the transmitter module (Please make sure that both switches on the transmitter module are OFF in two way mode) Release it in a few seconds. The RED LED on the transmitter module will flash, indicating the transmitter is ready to bind to the receiver., 3) Connect battery to the receiver while holding the F/S button on the receiver. The LED on the receiver will flash, indicating the binding process is completed., 4) Turn on the transmitter and connect battery to the receiver. The Green LED on the receiver will indicate the receiver is receiving commands from the transmitter., 2.2 Range check:, It is highly suggested to perform pre-flight range check. Caution must be paid when you perform range check in environment with metal fences, concrete buildings, or rows of trees. Loss of signal may be experienced from reflections., 1) Place the model at least two feet (60cm) above non-metal contaminated ground (like wooden bench)., 2) Place the receiver’s antennas apart. Do not let the antennas touch the ground., 3) Place the antenna of the transmitter in a vertical position., 4) Turn on the transmitter and receiver, press the F/S button of the transmitter for 4 seconds to enter range check mode, the RED LED of the transmitter module will be off, GREEN LED will flash rapidly, the BEEPER will sound. The effective distance will be decreased to 1/30 of full range., 5) Walk away from the model whi,
Features: Features: 1) Lighter in weight and smaller in dimension. ...HiModel
FRSKY RECEIVER UPGRADE LITE
| Refer to http | //www.frsky-rc.com/download.asp?id=22. for instructions and software etc. |
, , , , , , Specifications:, , , , , , , , , , , , ,
Features: FrSky receiver upgrade lite Includes/Requires: Includes: 1 x receiver ...HiModel
MOUNTING STAND FOR DHT-U/FLD-02
, , , , , , Specifications:, , , , , , , , , , , FrSky mounting stand for DHT-U/FLD-02, , ,
Includes/Requires: Includes: 1 x mounting stand for DHT-U/FLD-02HiModel
FRSKY 2.4G 10-CHANNEL TF RECEIVER TFRSP
| Number of Channels | up to 10 channels (CPPM for CH1~CH9, servo signal for CH5~CH10) |
| Operating Voltage Range | 3.5V~10V |
| Dimension | 53mm*30mm*11mm |
| Weight | 13.5g |
| Note | Increased duty means good signal reception, and vice verse. |
, , , , , , Specifications:, , , , , , , , , , , Specifications:, With RSSI Output, *CPPM is usable for reducing wirings to some flybar-less controllers, autopilot systems and homebrew UAV systems. Furthermore, it can be used as a wireless trainer system., Warning: Servos are not to be plugged into Channel CPPM and Channel RSSI, otherwise servos will get hot or may burn out., , ,
Features: Compatibility: FASST 2.4G: Air Systems (7CH Mode/Multi Mode) FrSky ...HiModel
FRSKY TWO-WAY 2.4G JR COMPATIBLE RADIO SYSTEM TELEMETRY DJT/D8R-II V2
| Model | DJT |
| Operating Voltage Range | 6.0V-13.0V |
| Operating Current | 50mA |
| Output Power | 60mW |
| Resolution | 11bit (3072) |
| Model | D8R |
| Weight | 16.2g |
| Dimension | 54*27*17mm |
| Operating Voltage Range | 4.0V-7.2V |
| Operating Current | 100mA |
| Specified Range | 1.5km (Ground Range) |
| Resolution | 11bit (3072) |
| Latency | 22ms |
| Number of Channels | 8CH |
| Analog voltage | 0~3.3V |
, , , , , , Specifications:, , , , , , , , , , , Transmitter module specifications:, Compatible with the following transmitters:, JR: 347/388/783/U8/PCM10/PCM10S/PCM10SX/, PCM10IIS/8103/J9303/MX-22/MX-24S/PX/9XII., Receiver specifications:, , ,
Features: The Two-way Radio System developed by FrSky provides an ...2 Reviews
HiModel
FRSKY LCD DISPLAY FLD-02 (UPGRADING VERSION FOR FLD-01)
| Model | FLD-02 |
| Compatibility | FrSky DFT, DJT and DHT |
| Dimension | 55*40*12mm |
| Pixel | 128*64 |
, , , , , , Specifications:, , , , , , , , , , , Compatibility:, Installation:, Connect FrSky LCD-fdd_lite to the four pins on FrSky telemetry module (Rxd, Txd, +5V, GND) by the provided cable. Confirm the orientation is correct and make sure both switches on telemetry module are OFF., , ,
Features: Features 1) Show all connected sensors data; 2) Capable ...